No hay artículos en el carro
No hay artículos en el carro
Compatibilidad:
Repuesto para Toyota:
Corolla 2000-2005 2010.
Matrix 2003-2010.
Yaris 2006-2010.
Camry 2002-2008.
Prius 2001-2008.
RAV4 2000-2008.
Highlander 2001-2007.
Solara 2002-2006.
Celica 2000-2005.
Echo 2000-2005
2000-2005 MR2 Spyder
Repuesto para Chevrolet:
- 2000-2002 Prizm
Repuesto para Scion:
- 2004-2006 xB
- 2010 tC
Repuesto para Pontiac:
- Vibe 2003-2010.
aperry
Comentado en los Estados Unidos el 23 de marzo de 2025
Perfect fit for a 2006 Toyota Solara 4 cylinder.The old connectors broke apart so the pins came out easy and fit perfectly into the new connectors.The pins are perfect also. Had broken license plate light connector where the ground wired pulled out of the pin. These pins happened to be the same size and worked perfectly!
RockIslandJoe
Comentado en los Estados Unidos el 18 de enero de 2025
Worked great for 2006 Toyota Sienna. Easy to remove the pins because the old clips disintegrated in my hands and the pins popped right in these replacements and everything is a perfect fit. I would replace these with each 120,000 mile spark plug change.
Gina Ramirez
Comentado en México el 30 de agosto de 2024
El producto llegó a tiempo y es muy parecido al original. Se los cambié a mi Sienna y fue muy sencillo y quedó como original. Los recomiendo ampliamente.
Russel N
Comentado en los Estados Unidos el 17 de junio de 2024
Took maybe 5 minutes per connector, 20 yo Lexus with typical coil over spark plug retainer tabs breaking off. Looked like no one had been in there before and yet one tab was already missing missing. They were so brittle, it's conceivable they might occasionally break of without touching anything, I was going to use the zip tie head retainer lock hack, but why when it is so fast and easy to do it right.Why was it so fast and easy? Because internally the entire plastic housing inside was disintegrating, crumbles to the touch thus the wires pull out freely. There are only two retainers on the connector, the single external plastic tab the holds the housing to the coil on and the single internal plastic tab that holds the wires/metal connector from pulling out and both crumbled away. I threw the included metal pin connectors in my misc electrical parts, didn't need them, my old wire insulation was not brittle, metal pin connections were tight when inserting them one by one loose.I can't tell if the new plastic is any better than the old crumbling plastic but we are not building a space ship here either.
Justin & Nancy Baugher
Comentado en los Estados Unidos el 23 de diciembre de 2024
These are a necessity when replacing spark plugs on a Toyota. Just note wire placement and break wires out of old plug. Clip the terminals into the new plug, install white retainer, and it’s ready.
Marcelo Quiroga
Comentado en los Estados Unidos el 29 de octubre de 2024
Excellent
Productos recomendados