No hay artículos en el carro
No hay artículos en el carro Especificaciones:
HICTOP Ender 3 Cama climatizada con cable de 24 V 220 W Compatible con impresoras 3D Creality Ender 3 Neo, Ender 3 Pro, Ender 3 V2, Endder 3 V2 Neo, Voxelab Aquila X2
Material: aluminio.
Tamaño de la cama climatizada: 235 x 235 x 3 mm.
Voltaje: 24 V.
Potencia: 220 W.
Color: negro.
El paquete incluye: 1 cama térmica Ender 3 con cable de 24 V 220 W compatible con impresoras 3D Creality Ender 3, Ender 3 Pro, Ender 3 V2
ricardo h.
Comentado en los Estados Unidos el 1 de febrero de 2025
Lisa
Comentado en los Estados Unidos el 17 de julio de 2024
After trouble shooting for weeks on Abnormal Temp failures on a S1 Pro, I finally cut the bed wire sheath apart and found a broken ground wire on my original bed. Outside of wire sheath looked perfectly fine but after removing sheath I finally found the problem. This bed is plug and play except it doesn’t have a ground wire. I drilled the back edge (where my original was) being careful not to drill into the heating area. Then I threaded it for a 8-32 tiny bolt. I also added insulation to the bottom of the bed and ran the wiring through some loom I already had. My printer is up and running again. I’d give 5 stars if it came with a ground wire and a beefier bed attachment to the bed.
melisandtony
Comentado en los Estados Unidos el 14 de noviembre de 2024
Broke the plug on my original bed plate when trying to install an upgrade. (Didn't realize it was glued to the board 🤦) Had the new bed installed and back to printing in about 15 minutes. Temp was spot on and performance was excellent.
Sascha4254
Comentado en los Estados Unidos el 13 de noviembre de 2024
Unfortunately, the bed size was a little bigger than expected so it was returned. Darn…
T. Dempsey
Comentado en los Estados Unidos el 2 de octubre de 2024
I was having a heck of a hard time getting things to stick to my old bed. eventually degraded all the way to using a non-contact thermometer and found I had a spot or 3 that were as much as 5°C colder than the rest of this bed. anyhow, this replacement was a perfect direct fit for my Ender 3 printer. I ended up adjusting the temperature down in my slicer a bit... more proof that the old bed was having issues. I'd reccomend this build plate.
Productos recomendados
Mex $499.99
Mex $ 234 .00 Mex $234.00