No hay artículos en el carro
No hay artículos en el carroDescripción del producto fs-sp 3000 (197") (5000 mm) Repuesto Splinter Guard para FS3000/2 – Riel de guía. Sustituye la 118 mm Splinter Guard 488467. From the Manufacturer Festool FS Guide Rails are available in eight different lengths from 32 inches to 197 inches (800 - 5000 mm), providing the right length for straight, splinterfree cutting in just about any application. The integrated splinterguard is a critical guide rail system component, and after some time and heavy use, will need to be replaced. Replace your splinterguard as needed to ensure perfect alignment of your guide rail to the cut line, and to protect against tear out, on cuts both with the grain and across. Though you should expect many cuts from your original splinterguard, its life expectancy is heavily dependent on your application. Keep your cuts perfectly splinterfree by periodically replacing your splinterguard, especially if you are switching between blades, or using the guide rail with more than one saw. Clear splinterguard enhances visibility of cut line. Includes one 197in (5000mm) Clear Splinterguard.
Dani
Comentado en España el 9 de marzo de 2025
Perfecta
Tom
Comentado en Alemania el 13 de marzo de 2025
Ich wusste jetzt nicht wieviel Sterne ich geben soll. Das Festool Produkt ist natürlich erwartungsgemäß einwandfrei. Aus Sparsamkeitsgründen habe ich zwischendurch ein no name in schwarz probiert. Dies ist schon nach kurzer Zeit abgegangen. Jetzt wieder beim Original.Allerdings war diesmal die Zustellung von Amazon grauenvoll. Der Zusteller hat es in den Briefkasten gestopft. So sah es dann auch aus. Die Umverkackung war total kaputt und selbst der eigentliche Karton war gerissen. Gottseidank war der Splittershutz unberührt davon.
Pierre
Comentado en Francia el 18 de enero de 2025
Très bonne adhésion sur mon rail Dewalt. Le pare éclats transparent est vraiment un plus pour viser juste.
RobotGardener
Comentado en Australia el 10 de abril de 2025
I think I'm too poor to own Festool any more, I seem to remember prices used to be a lot more reasonable. So it was a relief to find this here significantly cheaper than local stores, and I finally was able to refresh two 1400s, two 800s, a short one for an HKC, and I have a short bit left over.Putting the new splinterguard on was easy. Getting the old ones off was the hard part. Took a fair while with acetone and then IPA to get it properly clean. Worth the effort to do it right of course.
Joshua Bicknell
Comentado en los Estados Unidos el 29 de marzo de 2024
Plenty of length for 3 full tracks. Make sure you clean the old adhesive off your track and this is money. Festool does a great job with this.
Osker
Comentado en México el 17 de diciembre de 2021
Es un excelente producto precio calidad. Muy funcional, una alta calidad
Productos recomendados
Mex $520.41
Mex $ 239 .00 Mex $239.00
Mex $974.46
Mex $ 477 .00 Mex $477.00
Mex $2,272.01
Mex $ 1,090 .00 Mex $1,090.00