Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

IMPRESA - Paquete de 2 pernos hexagonales para barras olímpicas/tornillo de repuesto para barra olímpica

Envío gratis en pedidos superiores a Mex $600.00

Mex $343.90

Mex $ 189 .00 Mex $189.00

En stock

Acerca de este artículo

  • Paquete de 2 tornillos hexagonales especializados para barras olímpicas. No hay necesidad de comprar una nueva barra solo porque perdiste el tornillo, nuestro paquete de 2 te tiene cubierto. Te tendremos que levantar pesas en poco tiempo
  • Las barras olímpicas tienen un tornillo hexagonal muy especializado en el extremo de la barra, integral para mantener los pesos en su lugar. Con un tamaño muy específico, rosca y paso, puede ser difícil encontrar un reemplazo, hasta ahora
  • Compatible con barras olímpicas, barras de rizo, barras de tríceps y barras de mancuernas olímpicas, nuestros pernos de repuesto son un ajuste perfecto (2 por paquete). Requiere una llave Allen para una instalación adecuada en tu equipo de levantamiento de pesas
  • Nota: Este es un producto de repuesto de repuesto (producido por Impresa) que cumple con la calidad de los pernos OEM (basado en pruebas internas)



Descripción del producto

c
c
c
x
d

Patriot 24/7/365
Comentado en los Estados Unidos el 30 de junio de 2024
Not much to say they fit and were not rusted when they arrived. Very pleased.
Angel M.
Comentado en los Estados Unidos el 16 de septiembre de 2024
Worked great! Bought this to replace a loose bolt in my standard 45-lb barbell. Very good quality and perfect fit!
Jabez Harrington
Comentado en los Estados Unidos el 5 de julio de 2020
My old bolts in my 18 yr old Olympic bar have gotten pretty rusty & even lost one. Purchased these as a replacement & they were a good fit. Less likely to rust & look solid enough.The tool you need to get them screwed on isn't the standard tool you have in your chest though. I believe a hex design is needed, but a larger than normal one is needed. I have alot of tools & I had to go digging around in my specialty box for that size.I believe a common 3/8ths ratchet will fit into the bolt at an awkward angle & be enough to tighten the bolt though incase you do not have the hex design. I tried & it worked. Did not fit perfect, but enough for someone to get the job done. Hope this helped :)
Aaron
Comentado en Canadá el 2 de febrero de 2020
This product works good for replacing the oem bolts. After the first couple uses I put them in the barbell and noticed significant gains.
Paul
Comentado en Canadá el 2 de octubre de 2020
Works as advertised, replaces the stripped down bolts on my oldest barbell and they're holding so far after heavier pulling excercises. Might take a while to get in the mail internationally given current post system conditions but that's not the seller's fault.
Productos recomendados

Mex $362.71

Mex $ 199 .00 Mex $199.00

4.8
Elegir