No hay artículos en el carro
No hay artículos en el carroCompresor de suspensión de aire, sensor térmico.
Mike Motormann
Comentado en los Estados Unidos el 22 de abril de 2025
The air suspension on my 2011 Jeep GC stopped working and I got the dreaded service air suspension message. My OBD scanner showed that my compressor temp was constantly high even though the air compressor was never running (this was not a code, just an observation of the metrics). I replaced the sensor with this part which was nice they give you the extra screw and plastic nut. After the replacement my temp reading was the same as ambient temp again and my compressor would run. Unfortunately I was able to determine my my 14yr old compressor was not able to make enough pressure. I went on to replace that part and now my system is fully functioning and there are no warnings. The temp sensor did not come with a new compressor so I did in fact need both parts. You should find some good videos on youtube for how to replace.
Trey
Comentado en los Estados Unidos el 14 de octubre de 2023
Fixed my "suspension cooling down" issue.
Mario M Monti
Comentado en los Estados Unidos el 13 de septiembre de 2023
This fixed an issue with my 2014 RAM 1500 with an overheating message and service air suspension message.Installation isn't bad.Remove 4-5 plastic pop rivets, remove cover, use T25 with stubby bit and wrench, disconnect connector, twist plastic mount out, reverse procedure.I did have question for RMT and I did not get a response.Not sure if lost or else.
Productos recomendados