No hay artículos en el carro
No hay artículos en el carroImpresora 3D de resina MALYAN S100 Mini SLA LCD
Marillon
Comentado en Alemania el 29 de diciembre de 2024
Zu klein
John Stamos
Comentado en los Estados Unidos el 26 de mayo de 2021
I bought this printer a couple of months ago, all in all, it‘s a very good printer, but there are some issues.First, the good:- Largest build volume under 1000$- Very well constructed. If you‘re printing from a shop and not from home, you want something sturdy that‘s made of metal, not plastic.- great design. The printer has an automatic feed system which makes working with resin a lot cleaner. Just make sure to flush the pump with alcohol after every print to prevent it from seizing. It also has a door, rather than a lift-off top, which I prefer as you can check on your prints without risking damaging them.- exposure & lift settings can be adjusted while printing.- very smooth & steady z-axis movement.Now here are the issues:- When I got the printer there was some resin residue on the screen, which I had to remove. The Malyan Staff, which btw are very nice, responsive, and helpful, told me they test every printer before shipping it out. I cleaned them off, started a few test prints & after each one i ended up with resin marks again. —> the FEP liner had a number of very small holes that allowed resin to seep through. Not sure if their liner is low quality or if it was from the shipping. I replaced the liner, no more resin stains. Replacing the liner was very easy, but:- the vat design could be better. I’d prefer more control with the tightening of the film. Some films work better with slightly more or less tension. The spout is also more suitable for less viscous fluids. So don't pour the resin out through the spout. I use the feed system to pump the resin back into the bottle, but it‘s slow, as its intended purpose is to gently introduce resin into the vat without disturbing the print.- the printer has wifi but the browser interface could really be better. Would also be nice if Malyan would get their printer added to some of the slicing softwares, so you don‘t have to set everything manually.I hope the updated version will address the resin vat design and firmware/software updates. But ultimately, for 450$ this printer is really good!
Productos recomendados
Mex $7,900.00
Mex $ 1,881 .00 Mex $1,881.00
Mex $3,529.89
Mex $ 1,588 .00 Mex $1,588.00
Mex $14,119.01
Mex $ 1,881 .00 Mex $1,881.00