No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Especificaciones:
Tipo de artículo: soldadura de latón con borde de cuero
Material: latón
Color: amarillo
Tamaño: 0.039 in, 0.059 in, 0.079 in, 0.098 in, 0.118 in, 0.157 in, 0.197 in, 0.276 in, 0.354 in
Lista del paquete:
9 puntas de soldadura de cuero
Erick Vieyra
Comentado en México el 8 de enero de 2025
Realicé una primera compra y todas las puntas eran del mismo tamaño, 4mm, no correspondieron a la descripción que menciona que son 9 tamaños distintos, por lo que realicé devolución. Tras ello hice una segunda compra, con el mismo vendedor, y recibí el producto correctamente. Se puede usar con cautín sin ningún problema, las piezas son de gran calidad. Sólo recomiendo mayor supervisión por parte del vendedor de los paquetes para evitar devoluciones y molestias.
Nikole
Comentado en los Estados Unidos el 30 de marzo de 2022
The edges are dinged up on most of these. There are only 7 tips. I'm going to return.
Will Armstrong
Comentado en los Estados Unidos el 10 de noviembre de 2021
For the less mechanically inclined. You may need to burr a cheap solder pen. I clamp my rotary tool upright using a Vise Bench Vise Swivel Universal Table Vise Clamp-on Tilts Rotate 360° Universal Work 3" (v1) (also sold on amazon for $15-$19) and used a burr bit from a set also found for cheap here. The solder I used to test this was a $5 Harbor freight in store purchase. I asked the clerk if burring the hole to make it wider would be dangerous and he responded, "not at all, I've used a nail in one before". So I went home and widened it. Keep in mind that if you find the little solders on etsy or ebay that it is a really cheap solder with the only advantage being the temp control, but now that I know I can just do it myself I will just buy one that has a temp gauge. One more thing to note is I would recommend a solder with the screw tighten on the end. I will point this out in a pic for everyone. This way you can tighten these bits on since they have smooth ends that will not screw in like some other commonly used models. I'll also include a picture of the original tip in the harbor freight solder I bought as a reference. I really hope this helps everyone because these are a steal compared to anywhere else I've seen.
Productos recomendados
Mex $291.00
Mex $ 148 .00 Mex $148.00
Mex $239.00
Mex $ 133 .00 Mex $133.00
Mex $384.00
Mex $ 192 .00 Mex $192.00