No hay artículos en el carro
No hay artículos en el carroUno de los artículos más vendidos en Scuba Choice. Este artículo cuenta con todo lo que necesitas para comenzar, independientemente de si eres un principiante o un experto.
James
Comentado en los Estados Unidos el 17 de mayo de 2023
Easy to install and loads better then the original rubber strap design. I love how comfortable they are.
derrick
Comentado en Canadá el 2 de enero de 2021
when removing the old clips/fasteners, look for a stainless screw on the s/s clip, if there is one remove the screw then the s/s clip, if not, then use a dremel and grind them off. The new strap + fittings are easyly installed using a plumbers wrench. Simply squeeze the U clip onto the fin. Note, when sizing the new s/s straps, i have size 11 drysuit boots with Turtle fins, i selected size "M" straps and they are good. Overall, these are good quality, at a good price
Just Another Spider From Mars.
Comentado en los Estados Unidos el 23 de octubre de 2020
These are awesome! They brought my old yet otherwise unchanged Jet Fins into the modern era and they work beautifully. No problems with them losing their stretch or rusting. Love the oversized finger loop for carrying them down the beach in thick gloves as well. Installation was simple and intuitive enough, although it should be noted that you'll most likely need something like burly cable snips or an angle grinder to remove the old metal pins that holds your old Jet Fin straps on as they aren't exactly pliable. I was able to use a pair of bicycle cable cutters I have lying around to address this issue. Beyond that, the new straps were easy to install with a medium set of pliers.
Cliente de
Comentado en México el 8 de julio de 2019
Todo bien, fácil de instalar
Customer
Comentado en Canadá el 23 de diciembre de 2019
Very easy to install on fins. fast delivery and a sturdy spring
Justin DeLucca
Comentado en los Estados Unidos el 28 de noviembre de 2017
Just received them and so far, so good. Like others here have said, installation on the older model Twin Jets is very straightforward. Just use a hammer and thin punch on a firm surface to push out the pins, then use pliers to squeeze the pins of the spring straps once you have them in place. I used vice grips.First impression: They seem sturdy and well-made. There are considerably less failure points than the ones that it came with. Two swivels and buckles per fin? No thanks. I'm a little worried that the rubber finger pull might break after some use, so I'll comment back after a few months of sun and salt water.Fit: At first glance after installing they seemed small, but once I got my boot on and on there and slid the strap around my heel, I knew it was a good fit. It might just be stiff due to being new, but it feels very solid against my heel and it definitely holds my foot all the way into the fin. We'll see if it stretches with use.So far, very happy with it.*Edit*After 16 dives, I feel the M is too short a spring for my foot. I have a Medium sized twin jet fin for my 9.5 foot, as recommended by Scubapro.I wear soft booties and this spring was pushing my toes way too far through the opening at the front of the fin, my toes would be numb from loss of circulation after 30 minutes.While the spring performed as expected, the M was a size too small for me.
Productos recomendados
Mex $395.46
Mex $ 185 .00 Mex $185.00
Mex $329.17
Mex $ 181 .00 Mex $181.00
Mex $188.00
Mex $ 109 .00 Mex $109.00
Mex $1,022.00
Mex $ 459 .00 Mex $459.00