No hay artículos en el carro
No hay artículos en el carro 10 tornillos compuestos de 1-3/4 pulgadas. Revestimiento exterior, tratado a presión y compatible con madera ACQ.
- Dimensiones: diámetro del tornillo 0.195.3 pulgadas - ancho de la cabeza 0.25 pulgadas - altura de la cabeza 0.133 pulgadas Uso T20 Torx/Star Diver Bit
-Cabezal de disminución de 10 grados y roscas de inversión para evitar la hongo.
- Doble rosca (fino/grueso) ayuda a cortar a través del material de cubierta fibroso.
- Punta tipo 17 para arranques rápidos, ayuda a quitar el "camino" y una instalación más fácil sin pretaladrado
- Tratamiento térmico - Acero endurecido - 1200 horas de pruebas de agua salada en exteriores - Resistente a la corrosión
- Los usos incluyen tapa de plástico, PVC y revestimientos compuestos, fascia compuesta y barandilla compuesta.
Bryan Warren
Comentado en los Estados Unidos el 4 de agosto de 2024
These were exactly as depicted and worked well for the application but I had to transfer them to another container because there were religious quotes on the box hidden under the flap.
Louis Gargano
Comentado en los Estados Unidos el 9 de junio de 2024
The shorter length.
Special Eddie
Comentado en los Estados Unidos el 16 de octubre de 2024
Well the were the most cost effective screws out there. Of these screws. About 1 in 5 are bent and unusable. The self tapping cut that on the tip is missing on most of them. I did manage to find enough usable ones out of the 130 I preferred to finish my job.On the bright side the color matched my trek decking. The star bit works great too.
Bud O.
Comentado en los Estados Unidos el 7 de marzo de 2023
I'm giving these screws two stars as the color was good and they appear to be sturdy. First, they aren't very sharp to actually dig into the surface. But by far the biggest issue was even with a small pre-drilled hole they did not consistently fully sink into the surface completely. And when I went to remove the screw that stopped boring in, it would not come out.I learned this the smart way by doing some testing on a scrap. The trex split about an inch from the end using just one of these screws. So I pre-drilled a hole, and sent a screw in. I did this three times, one of them stopped boring in...I then could not remove the screw by reversing the driver. This would have been a HUGE issue if this was a 16' piece of trex that has a screw in limbo. I suspect there are better fish in the trex screw sea. As for me, I'm countersinking SS standard trim screws for this job. The tests went well, there is very minor dimpling with a countersunk hole.
Productos recomendados
