No hay artículos en el carro
No hay artículos en el carroA.A
Comentado en Canadá el 21 de noviembre de 2022
They work. The values are fairly respectable (the tolerance) meaning for example a 50k ohm normally is not off by much, like let’s say 48k for example. They hold in the breadboard pretty good but the legs are a bit delicate so as long as your not pushing down with a lot of force your good.
shrimpaoing
Comentado en Canadá el 30 de mayo de 2021
For Arduino project, when you need a 4.7 k or 2.29 ohm resistor, it is perfect !Easy to adjust with a multimeter and I didn't know but it is compatible with breadboard.Nice purchase.
Manuel Lopez
Comentado en México el 28 de abril de 2021
Excelente Calidad, llegó muy rápido y lo pude utilizar sin problema
Jean Bédard
Comentado en Canadá el 30 de enero de 2020
Donne du plaisir à varier les contrôles dans les projets tests.
Claude
Comentado en Canadá el 17 de mayo de 2019
I verified someone, they are OK, good price
Jonathan S.
Comentado en Canadá el 6 de marzo de 2019
Tested 3 of each value. All but, at most, half a dozen were within 10%. Those outside 10% were within 15%.Given the following testing procedure and the results in the inluded photo, I cannot suggest the overall tolerance is any worse than 10%, even for the sample testing 15%:With wiper pin in front, all were tested through the left pin with the wiper at each extreme. The meter was accurate to +-3%. Its leads were terminated in a breadboard. Given these conditions, 5% is likely a best case scenario of overall result accuracy.The product is as advertised. I'm happy to try seller's other items. This was a good buy.
Productos recomendados