Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

1/10.2 cm F6 envolvente trenzado Sleeving- 10 Ft- negro

Envío gratis en pedidos superiores a Mex $600.00

Mex $180.60

Mex $ 93 .00 Mex $93.00

En stock

Acerca de este artículo

  • F6S único de Split
  • Semi-rígida construcción trenzado hace que sea la solución ideal para situaciones donde la facilidad de instalación es en primer lugar.
  • El Split Lateral Permite que el tubo para abrir para acomodar una amplia variedad de necesidades
  • Y la trenza semirrígido configuración simplemente se cierra alrededor de toda la instalación sin necesidad de ningún tipo de cierres (adicional de velcro
  • Cinta


F6's unique split, semi-rigid braided construction makes it the ideal solution for situations where ease of installation is of primary importance. The lateral split allows the tube to open up to accommodate a wide variety of bundling requirements, and the semi-rigid braid configuration simply closes around the entire installation without the need for any additional fasteners. The 10 mil PET braid is lightweight, quiet, and flexible. The 25% edge overlap (at nominal diameter) allows coverage around inline plugs, connectors and splices. F6 will bend to a tight radius without distorting or splitting open and, unlike full rigid tubing, will not impair or affect the flexibility of harnesses. F6 allows for the addition or removal of wires without disassembly.


Enrique Moyao
Comentado en los Estados Unidos el 22 de agosto de 2017
good material. easy to use
Ron C
Comentado en los Estados Unidos el 27 de diciembre de 2017
This stuff is the answer for containing/bundling wires in any situation. A bit awkward to install 'til you get the hang of it. Have used it under the hood of the Mustang to tidy up smaller wiring and below my desk for smaller PC cables. Durable as the dickens, but it wants to unravel at the cut ends. Heating with a match helps some but is not a total solution for this. Nonetheless a great product.
wiggledbits
Comentado en los Estados Unidos el 22 de agosto de 2016
Had wire harness covers that were cracking and splitting. This covered and protected the wires while looking good. Easy to install.
leeg
Comentado en los Estados Unidos el 23 de octubre de 2016
Works great, used it to wrap some wires on a motorcycle. Looks far better than the plastic split loom.
Customer
Comentado en los Estados Unidos el 13 de junio de 2014
Installed a set of Hyper-Lite 3 Way LEDs on my 2012 Suzuki DL650A.While the wires used with the Hyper-Lite did not need any cover, I decided it did not look as good as I wanted it.So I used this product (1/4" ID) to cover the Hyper Lite LED wires.PROLooks greatHigh Quality ProductCovers 4 wires together of 18 gauge wires that had already been wrapped in electrical tape (So likely would hold 6 to 8 similar sized wires)CONCut edge sometimes is not clean and you many want to cut the end a few times till you get a clean square cut...Wish I had found this type of product years agoA little high in cost for the productOVERALLLooks much better than tie wrap cables. Easy to use. Holds well on a motorcycle. Would recommend to others
Productos recomendados

Mex $366.17

Mex $ 194 .00 Mex $194.00

4.4
Elegir