No hay artículos en el carro
No hay artículos en el carroAyden
Comentado en los Estados Unidos el 23 de febrero de 2025
I only ever have to level my printer every 30~ prints compared to almost every time before saves me tons of time.
Oscar Araque
Comentado en los Estados Unidos el 21 de febrero de 2024
excelente actualizacion
Amy Lou Clark
Comentado en los Estados Unidos el 11 de noviembre de 2024
Easy to install and worked as intended
DVB
Comentado en los Estados Unidos el 22 de noviembre de 2023
I have an Ender 3 Max Neo. The bed has four mounts, which come from the factory with four springs and four plastic leveling nuts. Many Ender 3 owners find these metal springs to be annoying because they do not tend to keep the bed level for very long before another adjustment becomes necessary. It is at this point that these owners discover that they can use silicone spacers instead of springs and anodized aluminum leveling nuts instead of plastic.One peculiarity of such an upgrade is that the Ender 3 printers (at least some of them, anyway) have the heated bed cabling routed through a little plastic fitting that the rear-left leveling screw passes through. This plastic fitting has a recess just large enough for the diameter of these silicone spacers. This recess has a bottom and that bottom has a certain thickness. As such, most other kits of this type contain three (3) 18mm spacers and one (1) 16mm spacer. That 16mm spacer is for the rear-left leveler, and it is shorter to allow for the thickness of that plastic part.That is where things go wrong with this kit: the kit does not come with a 16mm spacer; they're all 18mm. I have been advised by people who are familiar with my specific printer that I should not attempt to use an 18mm spacer in that rear left corner, and I believe them. There is a reason everyone else supplies a 16mm spacer for that position and I implore the manufacturer of this kit to revise this kit to include one.But the kit is not all bad. The spacers themselves appear fine, and the aluminum leveling nuts fit the existing M4-.07 screws as expected. And of course, red anodized aluminum is always pretty.Take care of the size issue on that one spacer and this becomes a solid kit.
ThinkPink
Comentado en los Estados Unidos el 21 de noviembre de 2023
Worked well easy to level the bed. Good quality
Productos recomendados