No hay artículos en el carro
No hay artículos en el carro
1. Rango de frecuencia: 0.1-1300MHz, cobertura continua HF / VHF / UHF
2. Impedancia de entrada/salida: 50.
3. Parámetros de medición: SWR, R, + Jx, -Jx, Z, pérdida de retorno.
4. Modo de medición: medición de un solo punto, (frecuencia) y modo TDR.
5. Rango de medición SWR: 1.0-1999 (modo de punto único), 1.0-20.0 (modo de escaneo).
6. Modo de visualización: visualización numérica, visualización de curvas, diagrama de simulación.
7. Tipo de conector: Conector tipo UHF N
8. VNA: SMA.
9. Tamaño LCD: 480 x 272 visualización LCD TFT de 4.3 pulgadas.
10. Fuente de alimentación: USB o ion de litio integrado.
11. Circuito de carga de iones de litio integrado y amplificador CC-CC.
12. Corriente máxima de carga: 5 V/1,5 A.
13. Método de almacenamiento externo: tarjeta TF.
Contenido del paquete:
1 anfitrión.
5 accesorios.
1 manual (idioma español no garantizado).
Henry M.
Comentado en los Estados Unidos el 18 de febrero de 2025
very useful, well worth the price.
C. P. J.
Comentado en los Estados Unidos el 31 de mayo de 2024
My Mini 1300 Antenna Analyzer arrived well packaged/protected and the shipping box did not show any damage.My first impressions are the instructions are very vague and so I will need to rely heavily on the internet to learn the finer details of its full potential. Upon removing the device from the packaging I was promptly cut by a sharp edge on the back of the case! And after setting down the device to tend to my wound, I then realized it does not rest on a flat surface - the case is tweaked or distorted causing it to rock noticeably. I do not know if this is poor craftmanship or prior damage.Next I attempted to plug in the charging USB cable. Again, the instructions are so poor I am not sure which port to use for charging. Also, there is a 'charging' lamp visible through a pin-hole at the bottom right of the front cover. It is just barely visible in a darkened room! Mine appears to be deeply recessed inside the case making it only visible from a very narrow field of view, like trying to look through a small straw held out at arms length!As I understand it, upon first use the device needs to go through a one-time internal calibration. But the required cable for this is not included with the accessories! So I skipped that for now and ordered the suggested cable set. Should be here soon...But the other calibration procedure requires the included resistive loads, however, none of the three are labeled! I have no clue which one is which - I think one is a dead short, another is wide open and the third is either a 5 Ohm or 50 Ohm resistive load. But until I test these with a multimeter I have no clue which one is which - absolutely no label or mark on any of the three.One of the attractions I have to purchase this Mini 1300 was the ability to work with PC software for a larger screen interface. Silly of me to assume that information would be included with the kit - it is not. Back to the internet to research more about the finer details of usage for this gadget...I really want to love the Mini 1300 Antenna Analyzer but so far I have not been impressed with it. The cheapness in me really wanted to go with one of the 'Nano' devices but the Mini 1300 looked like it was worth the 2x - 3x cost to get the quality and features I was anticipating.After I get the required jumpers for tuning, figure out what is what with the dummy loads, find the PC software this will interface with, and get a little experience with the tool, I will update my opinion at that time.
19detlef
Comentado en Alemania el 23 de marzo de 2024
Nur Englisch
GJJ
Comentado en los Estados Unidos el 10 de diciembre de 2024
I bought this for my amateur radio hobby. It's used to setup antennas from scratch and/or measure the effectiveness of existing antennas. The capabilities are many and the display is quite readable in all kinds of lighting.
terry likens
Comentado en los Estados Unidos el 19 de septiembre de 2024
I had to order adapter for my application. The ones that come with will work on my bird meter. Checked my anttena's with it worked perfect. Swr reading is the same as my watt meter. Definitely make tuning and knowing front to back ratios. Definitely able to measure db gain too. We'll built in metal case.
Productos recomendados
Mex $607.60
Mex $ 303 .00 Mex $303.00
Mex $8,689.86
Mex $ 1,881 .00 Mex $1,881.00
Mex $11,689.02
Mex $ 1,881 .00 Mex $1,881.00
Mex $209.00
Mex $ 121 .00 Mex $121.00
Mex $3,760.00
Mex $ 1,692 .00 Mex $1,692.00