No hay artículos en el carro
No hay artículos en el carroVentiladores Antec de 30 mm de grosor, ventiladores de caja de 140 mm x 30 mm, ventiladores PWM, 1500 RPM, 95.44 CFM, 1.94 mmH₂O, conector PWM de 4 pines, ventilador de 140 mm, serie Storm T3 3 paquetes
SomeBrownGuy
Comentado en los Estados Unidos el 20 de marzo de 2025
These fans are so quiet and move so much air. Even after almost a year of use, they are still quiet. My CPU and GPU temps are so low all without having to hear heavy fan noise. Definitely get these if you don't want to get the expensive Phantek 30mm fans.
D. Cole
Comentado en los Estados Unidos el 19 de junio de 2024
Even full tilt it doesn't sound terrible and they move a lot of air. They can chain but be careful they pull .38A EACH (for the 140mm) which means if you chain 3 together you'll be past the 1A motherboard headers are normally limited to. If you are getting the 120mm those can link 3 together since they only pull .21A each. Check your manual before linking 3 up. Slightly longer screws than my artic fans I replaced so replace screws too but overall awesome fans. Short cables that come with extensions which is nice I didn't need the extensions so it kept the cable management to a minimum.
Customer
Comentado en los Estados Unidos el 3 de septiembre de 2024
These fans look great and perform well. They seem so cool better than my previous fans.Despite the 5-star review, I do have two minor complaints:- There's no arrow on the side of the fan indicating the direction of airflow (which is odd... this is shown on every other case fan I've seen). Since I didn't want to install them to test this, I had to look up a YouTube video to verify that my guess was correct (the "sleeker" side with the Antec logo is the intake side).- The daisy-chain connector didn't fit through the fan cable hole on the front-top of my case, so I was unable to route the cables neatly through the back side of the case motherboard. This wasn't a huge deal for me since my case is mostly opaque, but if you're a stickler about tidy cable management, this could be a nuisance.
Donald Bosley
Comentado en los Estados Unidos el 26 de octubre de 2023
Short : I'm not unhappy with the fans, I wouldn't recommend against them, but I've been buying Antec for almost 25 years and they're misleading people on this one.Long : Bought an Antec 1FT Performance and liked how the 140mm T3 storms were performing, so I decided to buy three more for the top of the case. Opened the box and the fans are rated at 0.28A, not 0.36A, as parts of this page, the Antec website, and the box indicate. As I started digging around I noticed there are multiple, differing specs on this page for the same parts, and nowhere in their advertising materials are the lower specs discussed. Tried to get some info/confirmation from Antec but after four emails back and forth, the only useful information they would provide about the difference is that there are two versions, the case version (CPB) and the retail version (2PB).The fans in my case are 0.36A CPB, and the boxed ones are 0.28A 2PB. So it seems like they're putting the higher draw/higher power 0.36A CPB specs all over the place - box included - but selling you fans that move ~15-20% less air at a lower static pressure rating. Not exactly transparent, Antec.
Scott Robinson
Comentado en los Estados Unidos el 1 de octubre de 2023
I just put together a new rig, but ended up buying the case off of someone who needed the fans. I used old 120mm fans from my previous rig to get me by until these arrived. I don't know if it's the step up to 140's or the quality of the bearings, or both, but these are much quieter. Unfortunately my Corsair 5000T can only fit 2x140, 1x120, so I'm only using 2 for now, but that was my bad. I have a matching 120 for the rear now, and am ordering a second to put up front with the 2x140s.Installation can either be daisy chained, or each fan can be plugged in separately. Since these are not RGB, I don't see any benefit to separate power sources, so I chained them. Provided fan screws worked fine, and the rubber dampeners in the corners provided a snug, quiet fit.Right now they are humming along at 540 rpm, case temp 27C, CPU 33C, very little load
Productos recomendados