No hay artículos en el carro
No hay artículos en el carro [Nuevo lanzamiento 2023] [Plug and Play] [EMC integrado] [IP67 resistente al agua]
La mejor línea de corte "en forma de Z" en el mercado de faros de 7 pulgadas.
Compatibilidad: faros LED AUDEXEN de 7 pulgadas compatibles con Jeep Wrangler JK 2 Door 2008-2014; 2016-2018; Wrangler JK 4 Door 2008-2014; 2016-2018; Wrangler JL 2018-2022 (necesita añadir soporte JL: B0. V7V7T11 Q9T); Wrangler TJ Unlimited/LJ 2003-2005; Wrangler TJ 1998-2000; 2002-2005; Wrangler CJ-7 1976-1986.
Melanie
Comentado en los Estados Unidos el 9 de marzo de 2025
Happy with this purchase!!
Luis Gerardo Espinosa Rodriguez
Comentado en México el 23 de enero de 2025
Excelente intensidad de luz 100% recomendable
Alain Molimard
Comentado en Canadá el 16 de enero de 2025
Weird behavior. When engine is not running, key at acc all is good. But when engine is running, high beams are on even if light switch is off.
Neal
Comentado en Canadá el 6 de diciembre de 2024
Lights up road nicely , has the projector lines , great buy, I am happy
T J Johnson
Comentado en los Estados Unidos el 3 de noviembre de 2024
i Installed these lights on my Jeep JK over a year ago. They are still working great! They are much brighter, and with a better spread, than the stock units. They fit perfectly on the stock buckets. I went ahead and hooked up the turn signal haloes and the daytime running light haloes (I used a fuse tap in an unused fuse slot in the fuse box, which was hot with the key on).One warning - if you have to use the adaptor pigtail, it is not weather-tight and could corrode (especially in a salt environment). I recommend coating the contacts with silicone dielectric grease and also forcing it into the backs of the connectors to protect the wires... Refer to one of the YouTube videos, when realigning the new ones (I used the Chris Fix video).
Customer
Comentado en los Estados Unidos el 12 de abril de 2023
Just installed on my 2-door 2014 JK Wrangler. Fitting the headlights in was no problem - take the grille off, take 4 screws out of each of the old headlights, drop in the new ones with the included wiring adapter and re-use the old headlight rings to secure in place.The instructions for the daylight running lights and turn signal feature do not help at all, however. The instructions simply state to connect both to the fuse box. What I did was buy a fuse tap or "add-a-circuit" for the running lights, and spliced the wires from each headlight to it. Then found a location in the fuse box for something that would only be on if the car was running or in accessory (can't remember which spot, tbh). For the turn signal function, I spliced that wire into the existing turn signal wiring of the Jeep.Everything works great, my only complaint is that I had to do a bit of digging online to figure out the install. The instructions stating that the turn signal leads should be attached to the fuse box, as the running lights are, just didn't make any sense. They're a great set of lights though, very bright, very cool looking with the halo.If you're worried about wiring to the fuse box and splicing into other wiring - you could just plug them in with the included harness and they would work just fine as on/off headlights.
Productos recomendados