No hay artículos en el carro
No hay artículos en el carroCustomer
Comentado en Canadá el 8 de febrero de 2024
I love these, they are the perfect companion to the Autometer gauges
francisco r.
Comentado en México el 16 de enero de 2022
Buen precio sensillo util recomendado
Jeremy
Comentado en Australia el 19 de marzo de 2021
New gauges don’t fit in the cup, my water temp with LED is too long and I am worried it could earth out. Wrapped gauge with electrical tape and sits proud of the pod. Not ideal and no easy fix
Ash N
Comentado en Canadá el 18 de marzo de 2020
Does exactly what it should and holds a 52mm boost gauge perfectly. It is not well described exactly what the included brass fittings do but I didn't need to use them for my application.
likesilver
Comentado en los Estados Unidos el 29 de julio de 2018
I bought an Auto Meter 2204 Gauge Cup to mount a Max Tow water temp gauge on the dash of my older F350 IDI Turbo Diesel Utility Truck. I wanted a more accurate gauge to monitor the engine temp in my newly remanufuctured 7.3 IDI Turbo Diesel engine. The cup Installed easily, works well. I went ahead and bought the Max Tow matching Transmission Temp Gauge and the EGT Pyrometer and installed them side by side in Auto Meter Gauge Cups. All look good. The mounting cups look good on my dash and hold the gauges steady. If I decide to add a Turbo Boost Gauge, I will buy another.... Likesilver, San Leandro, CA.
Utah Pete
Comentado en los Estados Unidos el 17 de enero de 2012
I bought this item to mount a Cyberdyne ambient temperature gauge inside my Xterra. I needed something that was adaptable since I wasn't sure where I would end up mounting it.Other reviewers have said this is plastic. It's not. The base is a solid piece of steel and the screws attach the clamp securely to the base, holding it in the desired position without much chance of slipping. It has a fairly wide range of swivel around the axle, so as to obtain the desired angle of viewing.The housing is also a good quality steel. It has a fairly large hole at the back with a rubber grommet for feeding the wires through. There is also a long, wide slot from that hole along one side to the front, so the clamp can get a good grip on the meter.I'm very pleased with this unit. But then, I prefer function over form.
Productos recomendados