No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Reemplazo de montaje de ranura para CD iCarmount
Elige un soporte de ranura para CD para usar en el reproductor de CD para ahorrar espacio. No hay necesidad de preocuparse por que el calcomanía se derrita y ensucie tu salpicadero o parabrisas, o los clips de ventilación se dañen más.
Nuestra rótula es de aproximadamente 17,2 mm, perfecta para reemplazar tu soporte roto y ahorrar costos, y adecuada para la mayoría de los soportes de teléfono.
Firme y duradero
¿Cómo usarlo?
Coloca la bola de la junta en el soporte de montaje que viene con tu cuna, soporte magnético, soporte para tablet, GPS Garmin y así sucesivamente. Inserta la hoja en la ranura de CD, luego aprieta la tuerca.
Rob
Comentado en Australia el 26 de marzo de 2025
Using these with the ThtRht phone mount adapter set to mount my carpuride screen. Works great but with my model car the dash over hangs the CD slot so I can't tighten the bolt after inserting the mount in the slot. Had to tighten a bit then jam it in. But it works.
RobDog
Comentado en los Estados Unidos el 14 de febrero de 2025
This thing is a lot more robust than I expected. Works great with a fairly large after-market CarPlay add-on display; very stable.
Sel Lee
Comentado en Australia el 3 de abril de 2025
Sturdy, works great .
Favorite Christian Books
Comentado en los Estados Unidos el 12 de noviembre de 2024
I have an older model car that still have a CD drive in it. When I received a Carpuride display that was the best place to put it. The original CD slot mount I purchased from vendor broke within 6 months. I purchased this one and immediately noticed it was made out of sturdier plastic.Very little vibration to the device. So far so good!
WB
Comentado en los Estados Unidos el 5 de septiembre de 2024
I had to install the bracket with the wing not upside, instead of concealed on the underside. But, it's OK because the wing nut is hidden behind my phone when I'm using it. Otherwise it works as expected. If you have loose or additional panels added (like burlewood or whatever aftermarket additions you may have added) you may issues with control buttons sticking. For example, when I tap the a/c button up, that specific button, just below the bracket (where the tension is highest) usually gets stuck depressed. I have to push above the button on the panel to loose the up button back to normal. But it's not overly problematic. If you loosen the bracket until it stops happening it might be OK. But you'll run the risk of the bracket being too loose and dislodged.Other than that, it works well.
Paul Medina
Comentado en México el 18 de julio de 2023
A diferencia del anterior que tenia, este trae unas gomas que hacen que no se mueva tanto y el ajuste parece no perder.
Productos recomendados
Mex $415.33
Mex $ 224 .00 Mex $224.00