No hay artículos en el carro
No hay artículos en el carro37051 Tipo 1, 37051 Tipo 2, 8000 Tipo 2, 8000 Tipo 3, 8000 Tipo 4, 8000 Tipo 5, 8000 Tipo 6, 8000 Tipo 7, 8000 Tipo 8, 8000 Tipo 9, 8000 Tipo A, 8000 Tipo AA, 8008 Tipo 1, 8008 Tipo 2, 8008 Tipo 3, 8008 Tipo 4, 8008 Tipo 5, 8008 Tipo 6, 8010 Tipo 2, 8010 Tipo 3, 8018 Tipo 1, 8019 Tipo 1, LM100 Tipo 1, LM100 Tipo 2, LM100 Tipo 3, LM175 Tipo 1, LM175 1820 Tipo 1, LM1900 Tipo 1, LM400 Tipo 1, M100 Tipo 1, M100 Tipo 2, M200-BDK Tipo 1, M200-BDK Tipo 2, M200-BDK Tipo 3, M200-BDK Tipo 4, M200-BDK Tipo 5, M200-BDK Tipo 6, M200-BDK Tipo 7, M300 Tipo 1, M300 Tipo 2, M400 Tipo 1, M700 Tipo 1, M700 Tipo 2, MM275 Tipo 1, 1800 Tipo 1, MM1800 Tipo 1. Tipo 1, MM450 Tipo 1, MM450 Tipo 2, MM525 Tipo 1, MM525 Tipo 2, MM525 Tipo 3, MM525 Tipo 4, MM575 Tipo 1, MM600 Tipo 1, MM600 Tipo 2, MM600S Tipo 2, MM675 Tipo 1, MM675 Tipo 2, MM850 Tipo 1, MM850 Tipo 2, MM850 Tipo 3, MM850 Tipo 4, MM850 Tipo 5, MM850S Tipo 4, MM875 Tipo 1, MM875 Tipo 2, MM875 Tipo 3
George J. Perkins
Comentado en los Estados Unidos el 3 de noviembre de 2024
DIY motor fix!
Robert Parks
Comentado en los Estados Unidos el 3 de septiembre de 2024
These motor brushes were exact replacements and worked perfectly.
Trelane Esq
Comentado en los Estados Unidos el 11 de septiembre de 2024
They fixed my B&D lawn mower.
kindle/kobo customer
Comentado en los Estados Unidos el 1 de septiembre de 2024
Fits perfectly - original had a non-removable clasp to feed wire - so cut original braid wire to brush with short lead & soldered to new brush braid. an appropriate clasp would work as well. Full power after install.
RS
Comentado en los Estados Unidos el 5 de mayo de 2022
The copper braid on these brushes is a lot thinner than the braid of the original brushes on the 5 horsepower 24 volt Black & Decker CMM1000. They fit, but they might be better suited for a higher voltage mower (ie 36 or 48 volt), since the current is lower on higher voltage motors. Would rate them 5 stars for value.If soldering them to the old partially corroded wires, be sure to use flux and a high heat iron since the power wires on the 24 volt CMM1000 are very thick.Before you re-install the brushes, be sure to also clean all the commutator contacts on the armature, or you may have a large power loss (as I learned the hard way). It is easier to clean the contacts with the brushes out. I used a rag with isopropyl alcohol, then sanded them with 1000 grit (ie very very fine) sandpaper, then more wiping with isopropyl alcohol. Once I cleaned the contacts, replaced the brushes, and fully charged the batteries, the mower seemed to have most of its original power. Not bad for a 15 year old mower on its second set of batteries.By the way, I love the Black and Decker cordless mowers - they have been very dependable.
Productos recomendados
Mex $102.00
Mex $ 53 .00 Mex $53.00
Mex $221.60
Mex $ 121 .00 Mex $121.00
Mex $753.19
Mex $ 338 .00 Mex $338.00