No hay artículos en el carro
No hay artículos en el carro
Especificaciones del producto:
- Tipo: boquilla V6 de acero endurecido.
- Material: acero endurecido de alta resistencia.
- Tamaño: 0,4 mm.
- Ventaja: Capaz de imprimir más suavemente y de 10 a 20, más alto, según el medio ambiente.
[Garantía]
- Respetamos a cada cliente. Por lo tanto, cada motor paso a paso pasó el control de calidad antes del envío. Pero si tienes problemas, todavía proporcionamos devolución/cambio gratis en 90 días, por favor ponte en contacto con nosotros.
[Lista de embalaje]
-5 boquillas V6 de acero endurecido de 0,4 mm
Lauren Miller
Comentado en los Estados Unidos el 4 de febrero de 2025
I purchased the steel nozzles and received used brass nozzles that are burned with filament still stuck in a couple
MakeBuildDad
Comentado en los Estados Unidos el 16 de octubre de 2023
Overall the nozzles worked in my BIqu H2V2 extruder and have been working nicely. My biggest issue with these nozzles is that the nozzle is too big for a 7mm socket but too small for an 8mm socket, making it difficult to screw these nozzles in even though they are standard v6 style. I had to use a set of pliers to screw them in which makes them more likely to strip out or break off in the heater block. It isn't the end of the world, but it is something to be aware of before purchasing. If you are using a torque wrench with a 7mm socket and want to continue doing that, you may want to get something that is confirmed to fit that size socket.
vinnd
Comentado en los Estados Unidos el 25 de septiembre de 2023
I have 5 3d printers and swapped out to metal print nozzles for durability, however I kept getting nozzle blockages until I realized the ones I was using, didnt have a long enough thread length to close the nozzle off to the inside of the hot end.So I tried these with the longer thread and have not had one single clog. Great value and peace of mind.
Springer_Bob
Comentado en los Estados Unidos el 23 de septiembre de 2022
I do a LOT of 3D printing. I had been buying regular brass nozzles and honestly they just don't hold up that well. I thought I would give these steel nozzles a try and I was not disappointed. The fit and finish is right up there with the better brass nozzles I have used. Calibration was no different than brass nozzles. Print quality looks good so far. All in all, so far so good. Time will tell how these hold up.
Brett
Comentado en los Estados Unidos el 7 de noviembre de 2021
Bought these for my ender 3 v2. Had clog after clog. Put a brass nozzle back on and problem solved. I'm assuming they can't maintain heat well enough to keep the filament flowing. Perhaps they are better for a more powerful printer.
Productos recomendados
Mex $380.00
Mex $ 171 .00 Mex $171.00
Mex $571.85
Mex $ 314 .00 Mex $314.00
Mex $172.00
Mex $ 98 .00 Mex $98.00