No hay artículos en el carro
No hay artículos en el carroDescripción del producto
BQLZR Noiseless Good Balance - Pastilla de guitarra de 4 cuerdas
El color del artículo puede ser diferente al de la imagen debido a la aberración. Cubierta: Pieza de poste de plástico: Bobina de acero: cable de plástico: 4 conductas con imán de escudo. Resistencia de salida de cerámica: 11 K. El paquete incluye: 1 pastilla de graves grandes
Esta es una buena pastilla magnética adecuada para la mayoría de instrumentos de cuerda de metal.
Calidad increíble. Sin ruido con señal extremadamente potente.
oldenoughtoknow
Comentado en Canadá el 8 de agosto de 2024
This pickup really sounds good, no question.Found the correct combination of Red/Green and White/ black wires for each potentiometer. Really sounds good with both coils engaged.
Matty
Comentado en Canadá el 23 de junio de 2024
I always wanted a Musicman Stingray, because that is my favourate bass tone... but with this, I get a great representation of that tone without the cost, and I still can use my nice old light-weight Yamaha bass.I measured the resistance of the wires to figure out which wires go with each coil. I still wired it wrong the first couple tries, probably because you can't figure out the polarity without some trial and error. I made the mistake of assuming the wire colours are the same as Seymour Duncan pickups, but they are not. When wired like that, the pickup sounded thin and full of hum in both switch settings. Eventually I wired it like this diagram that I attached and it gave a useful and full sounding tone for both Parallel and Series settings. I'd say it's worth it for the tonal options to have both Series and Parallel humbucking options if you do have a DPDT switch you can use. I kept my stock precision pickup installed and I would say it's even useful to have the option to use this pickup in combination with a typical precision bass pickup; they compliment each other well (so I will keep this layout). Or, I'd say it may be worth it to buy two of these and have one in the bridge position and one in the neck position.The tone is fat and tight. My precision pickup sounds a little rounder and looser, but I would say that is mostly due to the body position. I'd be curious what another of these would sound like in the neck position.All in all, this is a crazy good value... especially now that I have given the proper wire colours for wiring a series/parallel switch.
カスタマー
Comentado en Japón el 18 de noviembre de 2024
取り付ける楽器の音がしっかり出る。音質は大人しく感じる。ドンシャリでもなく、ブリブリにもならない。フラットな出音。ただ、ローはデカい。しかしプリアンプなどでローを上げるとオーバードライブをかけた時みたいな、音圧に曇りが掛かる感じがある。安いベースに最初から付いてくるピックアップよりは確実に良い音が出る。芯があり、音程感もあり、立ち上がりも早い。クセは本当にない。スイッチを取り付けて、シリーズ、パラレル、タップが出来るように取り付けた。アクティブ回路で味付けが出来るサーキットを搭載するのがおすすめ。バルトリーニとか、スティングレイの標準のサーキットとか。ナチュラルなサーキットは、変化が乏しくて面白くない。むしろパッシブが好み。パッシブにして、250KΩ、47kμfが好みだった。ハムバッカーだから500KΩ、22kμfが定番だけど。
JonXiuh
Comentado en México el 29 de junio de 2023
Buena relación calidad precio
David Stout
Comentado en los Estados Unidos el 24 de julio de 2021
After seeing many reviews for these pickups, all positive, I decided to get a pair.I was looking to upgrade my Glarry GJazz bass. While it was okay stock, I wanted to wake up the tone, among other things.The pickups came sooner than promised, well-packaged, and in perfect condition. Mounting springs and screws are included.These things are MASSIVE. The pole pieces, magnets, and apparently the base plate are all huge and heavy. They are sealed with flexible epoxy, to prevent microphonic feedback and hold it all together.I made a routing template out of 1/4" acrylic by tracing around the base. The stock depth was used when I enlarged the pickup holes to accept these. You can also use MDF to make a template, purchase one, or if you are REALLY steady, use a tracing and rout freehand.They are wired with 4 color-coded conductors, plus a bare braid for ground. The conductor wires are red for hot, black for neutral with a white and green soldered together joining the coils. This is cool, because these two wires can be separated and wired to a switch, or push-pull pot, to tap the coils. I didn't do that, but insulated the connections and taped them to the harness, so I have the option to do this mod later.I wired them in with 4 new 500k ohm pots from TAOT, and some new .022 microfarad poly capacitors. A switch was used as a pickup selector, and it was wired using a Les Paul patterned circuit.Well, once it was done and plugged in, I was blown away! These pickups have some OUTPUT, and the sound is incredible!! Even my little 70-watt GK Backline 110 sounded big and powerful.The tonal response is WIDE. They are bright and punchy, with a crystal clear top end end and a huge thundering bottom end. There is no noise whatsoever, and they respond really well to both tonal and volume input.These pickups have given fresh life and lots of power to my Glarry, it's like a whole new instrument.If you don't mind a bit of routing and wiring, then these bargain pickups are a good upgrade option for you.
David Smith
Comentado en los Estados Unidos el 16 de abril de 2020
This pickup is a beast! Excellent tight punchy tone with gobs of output. Much better than the dead sounding sterling stock pickup.I bought a egg shape Music Man pickgaurd and put it on a Dean Zone bass. I routed out a cavity for the pickup took out the Dean soapbar pickup and its a killer bass now. My friends son has it now and his bass teacher was blown away by this pickups sound..
Productos recomendados
Mex $246.89
Mex $ 133 .00 Mex $133.00
Mex $273.00
Mex $ 163 .00 Mex $163.00
Mex $415.10
Mex $ 199 .00 Mex $199.00
Artec POA4 Alnico 5 Tono Vintage Split Pastilla P-Bass Set 8,4K para Precision Bass 4 Cuerdas, Negro
Mex $507.30
Mex $ 273 .00 Mex $273.00
Mex $4,628.14
Mex $ 1,881 .00 Mex $1,881.00