No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Fácil de instalar
Amplias aplicaciones
Diseño de funda resistente a la intemperie
Construido con fusible
WMW
Comentado en los Estados Unidos el 7 de febrero de 2025
I bought this to install on my Indian bobber. It is good quality and would have been fine except my trickle charger connector was reversed so I couldn’t use it on the bobber. I will use it on my Indian springfield for my heated gear for cold weather travel instead. Well made should last as long as the bike. Easy to install.
Ray Gale
Comentado en Australia el 22 de febrero de 2025
The leads are meaty, I think the add states 12 G, which for us Metrics is 2.5 sq MM. They are multi stranded and are flexible enough to tuck in tight spots, the standard ATC fuse holder is weather proof and comes with a 15 Amp fuse standard. The 2 Ft length is just right for a battery tender connection on my Honda Rebel.
SHorton
Comentado en los Estados Unidos el 13 de agosto de 2024
Overall good quality, however, one of the loop ends pulled right off and I needed to redo it with a new one. Otherwise, worked as expected.
BT
Comentado en los Estados Unidos el 3 de junio de 2024
This was an upgrade for a much thinner fused SAE cable. This is nice and thick and doesn’t get too hot. I wired it directly to my battery (which happens to be in the trunk of my car) and used it to power an Ecoflow River on a road trip. The Ecoflow was powering a 12v fridge and it kept my Ecoflow charged up without any issues. I cannot stress enough, this did not get too hot, just warm. I had a much thinner SAE cable previously on there and it worked fine for using a trickle charger on my 12v car battery, but anything beyond the trickle charge made the wiring heat up way too much for my comfort. This continuously put out 90-100 watts for 8+ hours at a time and I never had any issues. When I stopped, I’d unplug the SAE cable so I didn’t drain my car battery. It came with a 10 amp fuse installed, I replaced it with a 15 amp fuse to allow the maximum 12V/100 watt input into the Ecoflow without blowing any fuses. Again, it will get warm but the thicker gauge wire handled it just fine for my application.
William Brummett
Comentado en los Estados Unidos el 16 de noviembre de 2024
Good heavy 30 amp wire and a 10 amp fuse. It works great.
Productos recomendados
Mex $1,166.00
Mex $ 513 .00 Mex $513.00