No hay artículos en el carro
No hay artículos en el carroKit de bloque de calefacción de cerámica serie K1: kit de boquilla de intercambio rápido
dm
Comentado en los Estados Unidos el 6 de junio de 2024
I replaced the hot end in my k1 with this, because it said it was compatible. It is. Not hard to do, comes with instructions of how. This uses different nozzles from the k1. Easier to load filament into, it gets hotter faster, seems to keep up with high melt rate too. I'm getting cleaner prints, a little bit faster prints, and it's nice to have hardened tips in the process. As far as I can tell, 0.4, 0.6, and 0.8 sizes available. No 0.2 that I've seen. If that matters. 0.2 would be nice. I don't usually care about faster, just accurate... 0.4mm will do for now. A worthwhile upgrade.
Riz Mubashir
Comentado en los Estados Unidos el 17 de junio de 2024
Hot end is amazing ty for a great product
julien dufour gilbert
Comentado en Canadá el 29 de diciembre de 2024
A transformé ma tete de K1 max en K1C
Productos recomendados