No hay artículos en el carro
No hay artículos en el carroMás información del producto
Stuff
Comentado en los Estados Unidos el 1 de marzo de 2025
Works great. Cuts stone ledger panels with ease. I would purchase again when I need to replace the one I have.
Aaron D.
Comentado en los Estados Unidos el 23 de junio de 2024
I originally ordered this to cut a corner out of my driveway where we experienced some settling and cracking. The slab ended up being 3-4" thick, with a couple pieces of 1/2" rebar. I took it slowly and had a steady flow of water flowing onto the blade and it did a great job of cutting. I took 15-20 minutes to cut this section out of my driveway. I was very nervous about the rebar but it turned out to not be an issue. I just took it slowly.After that project, I wasn't sure I'd use the blade again, but I don't throw tools away unless they're actually broken and unrepairable. So, into the garage this went. It fell on the floor and sat in a spot by the door that got wet over and over. I found it with one side covered in rust and put it away again.This week I was cutting a slab of granite and was using a tile saw blade meant for granite and natural stone tile. Then I remembered this thing. Though marketed for masonry, I figured I'd give it a shot. The diamond pattern is more aggressive with a thicker kerf. I tested on a scrap piece first and It blew me away how well it cut. The rust was a complete non-issue.I cut another ~20 linear feet of granite and it had plenty of life left. Way better than the tile saw blade. Again, water was mandatory so I could see what I was doing and keep the mess and dust down.I found that the absolute best way to do this alone was to set my workpiece up on a slight angle, so that I was sawing "downhill" and make one very shallow pass with a hose pouring water onto the slab. Then for the next cut, I put the water stream into the kerf behind the saw and it flowed down to the cut to cool and lubricate. I made a total of three progressively deeper passes then the fourth pass finished the cut. I was left with a beautiful edge, ready for polishing.10/10 experience and fantastic value.I did not have any issues with the brass insert.
oscar edmundo
Comentado en México el 18 de agosto de 2023
La marca lo dice todo excelente
Anthony Jones
Comentado en Canadá el 8 de abril de 2023
Blade worked better than I expected. Reno'i g the basement needed to cut the concrete for plumbing... This cut the concrete with ease.. was able to a foot wide by 8ft. No issues... Obviously you have to let the blade cool down every so often.
EBon
Comentado en Canadá el 26 de julio de 2020
The blade worked great and went through the porcelain tiles effortlessly. The washer adapter was OK and fit my wet saw. However, it did chip the tiles when cutting. This occurred whether I went slow or fast. In my case it did not matter as all cuts are hidden by trim.
JUAN CORREA
Comentado en México el 23 de junio de 2020
Se trabaja muy bien, facilita mucho el corte.
Roger Curtis
Comentado en Canadá el 20 de noviembre de 2019
These circular saw blades easily cost twice as much elsewhere. I used it to cut one end of a dozen or so 2" x 16" x 24" patio stones weighing 23 pounds each. Great, smooth and quick cuts.
Productos recomendados
Mex $319.54
Mex $ 169 .00 Mex $169.00
Mex $1,172.86
Mex $ 551 .00 Mex $551.00
Mex $485.99
Mex $ 228 .00 Mex $228.00
Mex $375.05
Mex $ 195 .00 Mex $195.00