No hay artículos en el carro
No hay artículos en el carroJoseph Habkouk
Comentado en Australia el 6 de enero de 2023
Wrong part didn’t fit
Jochen S.
Comentado en Alemania el 13 de junio de 2022
Schon nach kurzer Zeit defekt. Ganz schlechte Qualität
Brayan G
Comentado en México el 14 de mayo de 2022
Esta super bien.
esteban roman torres
Comentado en México el 7 de octubre de 2022
Todo me gusto preciony tiempo
Roy
Comentado en Canadá el 4 de julio de 2021
I just installed this item and it works. Time will tell if it lasts over time. The price for this item (I believe I paid $ 158.00) is very high so I recommend that you shop around. I recommend that you buy the top grade part made by Dometic since it is a big job to install and you do not want a generic equivalent that may wear out sooner. Good Luck !!
jose luis rosas vazquez
Comentado en México el 21 de mayo de 2021
Excelente,justo lo que necesitaba
Fabian Luna
Comentado en México el 13 de diciembre de 2019
El kit completo llegó antes de tiempo
BoaterGuy
Comentado en los Estados Unidos el 16 de febrero de 2018
Original billows pump LEAKED brown stuff into bilge = BIG MESS !! The plastic billows actually split which allowed "STUFF" to escape pass the billows upward and out of the pump housing and into the bilge. The duckbill rubber valves are replaced routinely every 3 years. From now on, the billows will be replaced then also. Somewhat expensive, but WHAT A MESS. Remove pump from boat to service. Muriatic acid works best to "clean" pump housing & etc. Wear eye protection and rubber gloves with muriatic acid. When installing the duckbill valves, orient them in vertical position. If they are horizontal, the lower lip of the valve seems to "sag" prematurely, necessitating early replacement. Flush 2 full bowls of water with sudsy dish soap through system whenever leaving boat for more than a few days to prevent more frequent repairs and keep hoses clear of smelly "stuff".
Andrei
Recommended
Productos recomendados