No hay artículos en el carro
No hay artículos en el carroAdaptadores de acero tratado térmicamente de grado industrial para perforación de núcleos. Adaptador de 1-1/4"-7 macho a SDS Plus.
Cecily
Comentado en los Estados Unidos el 17 de febrero de 2024
This is what i needed to adapt my 4.25" core hole bit to my hilti drill. Did the job and plenty of life left in it.
JEuvin
Comentado en los Estados Unidos el 19 de noviembre de 2024
They don't last more then 8 hours.
Frank
Comentado en los Estados Unidos el 17 de marzo de 2023
I have now needed to buy 3 of these. The 1st one was OK, was able to use it in a 4" concrete hole saw several times. Then it broke at the bit shaft. Ordered a second one, last about 5 minutes. Broke in same spot. (and no, I did not hit any rebar). I have just ordered another, as I need to finish a job I've already started. Not sure if these are harden steel or not. But I don't think they should break so easily. If the new one doesn't s last, will look for an alternative.
Wayne
Comentado en los Estados Unidos el 23 de septiembre de 2023
A little pricey but worked as described
John Makar
Comentado en los Estados Unidos el 20 de agosto de 2018
The unit was paired up with a 6" diameter core drill bit and an SDS Plus drill, used lots of water and a vacuum (made up a jig to trap the water) - it worked extremely well to drill 14 holes in 5"+ thick solid concrete floor. Went slow and it worked perfectly. Glad to have purchased this adapter.
Productos recomendados
Mex $1,312.20
Mex $ 616 .00 Mex $616.00