No hay artículos en el carro
No hay artículos en el carroGuía de riel lineal ENOMAKER Ender 3 S1 para eje Z
G W Renzelman
Comentado en los Estados Unidos el 23 de marzo de 2023
Easy to install, had it up and running in less than a hour.
Efren
Comentado en México el 13 de enero de 2023
El producto llegó bien y funciona correctamente, me ayudo bastante a reducir vibraciones e imprimir a velocidades más altas, falta ver la durabilidad pero no imprimo mucho solo proyectos personales.
Brian P.
Comentado en los Estados Unidos el 13 de agosto de 2022
At first glance appears to be good for the money, but there were issues. The replacement mounting plate is off by a few thousanths, which is just enough that a Bondtech DDX extruder will not fit onto it without modification. Had to oversize the holes in the Bondtech by a few thousanths each to make it fit properly. Also, the skies for the timing belt are set too far towards the center and the timing belt wouldn't fit with the stock tensioner attached. Had to get a hacksaw out and cut two new slots a little further out on the bracket so the belts would slide in. Overall, not terrible for the price, but be prepared to do a few modifications to make it work
Seth
Comentado en los Estados Unidos el 21 de octubre de 2022
If you upgrade to the slide rail you will need a longer belt.
Tommy Martin
Comentado en los Estados Unidos el 16 de septiembre de 2022
Everything fits well. As with any upgrade to a 3D printer it takes a little finesse to get everything dialed in. The linear rails that come with this kit are low cost generic rails and require cleaning and lubricant but they work well. Check out YouTube for videos on how to do that.
Productos recomendados
Mex $3,016.70
Mex $ 1,508 .00 Mex $1,508.00
Mex $2,516.75
Mex $ 1,006 .00 Mex $1,006.00
Mex $290.00
Mex $ 133 .00 Mex $133.00