No hay artículos en el carro
No hay artículos en el carroEl Flfint se adapta a encendedor suave Clipper
Dave
Comentado en los Estados Unidos el 19 de febrero de 2025
These fit in any clipper lighter I have. Now I have a couple spare ones.*the plastic screw on the bottom of the unit it very tight. A quarter can be used to loosen it. I find that zippo flints work the best.Stay away from bulk cheep ones. I had some problems with those. Also keep the strike wheel clean. There are several videos on utube how to maintain those.
Katladi1966
Comentado en los Estados Unidos el 21 de mayo de 2024
I ordered a set of these from one seller, and they were too small. Ordered from a second seller, and they were the actual ones made by clipper, which I hate. (The lobes on them hurt my poor old thumb.) These are exactly what I wanted. They are round,which makes for easy striking. And they actually fit my Clipper lighters perfectly. Will buy again.
ever ray humphrey
Comentado en los Estados Unidos el 17 de diciembre de 2024
these fit very well, if not exactly, for the standar clipper lighter. i really like that the wheels are rounded, much more comfortable & easier to use
A guy
Comentado en los Estados Unidos el 23 de septiembre de 2024
Surprisingly they fit really good and it came with five holders each with a flint in them and the round flint wheels. These holders all snapped into a standard clipper lighter nicely and the flint wheel is a bit bigger than the stock one and flicks over easy.Clipper lighters use thicker flint than the standard Zippo size and if you use one of those thinner ones in a clipper, you can get it to spark and flick over but then it'll get stuck and grind and you have to force it to spin over, and then after a couple flicks it will literally jam up and get stuck again because the thinner flint allows too much movement in the holder.These all seem to be okay and close to the stock clipper size. For more flints you'll have to look for something that says it's 2.5mm or 2.55 instead of the common Zippo 2.2 size. There's some on Amazon I have with a picture showing 2.55mm.....although I found mine to be closer to 2.5mm as many measured slightly less that that. Nevertheless that is about what a stock clipper flint measures and they work perfectly fine.If somebody's holders are not big enough where they're falling out and too loose from other sellers or even if you get a bad one from this, you can at least keep the wheels and swap out the flint wheels and put them in your stock clipper holder and at least have spares. But the 5 I got all snapped in just like the stock holder.
Customer
Comentado en los Estados Unidos el 25 de abril de 2024
A flame with every spark so far. Hopefully they last a long time.
Productos recomendados
Mex $359.99
Mex $ 172 .00 Mex $172.00
Mex $277.00
Mex $ 157 .00 Mex $157.00
Mex $304.20
Mex $ 164 .00 Mex $164.00
Mex $631.44
Mex $ 315 .00 Mex $315.00