No hay artículos en el carro
No hay artículos en el carroConstruido con construcción patentada de Gates, este cinturón tiene una combinación superior de capacidad de carga flexible y de carga, así como menos elasticidad, lo que resulta en menos mantenimiento. Esto proporciona un rendimiento superior en las unidades industriales de la sección A, B y C más resistentes de alta resistencia. Adecuado para todas las aplicaciones industriales, especialmente donde se requieren diámetros de polea pequeños o submínimos.
- Las muescas moldeadas en la correa durante la fabricación hacen que esta correa sea adecuada para unidades con poleas de diámetro más pequeño.
Patrick H.
Comentado en los Estados Unidos el 9 de enero de 2020
It fits, arrived fast, it's a belt. 'Nuff said
J&J
Comentado en los Estados Unidos el 22 de julio de 2019
Fit perfectly on my old craftsman 100 table saw
Herbert Childs
Comentado en los Estados Unidos el 20 de agosto de 2018
This belt is used an a Craftsman contractor style table saw. It replaced the well worn non-cogged original belt. It is a much more flexible belt than the original V-belt. I tried replacing with the original type belt and had a pronounced vibration when running and a shudder on startup and shutdown. The cogged belt very nearly eliminated this resulting in a much quieter and smoother running saw. I believe this to be a better solution than a linked belt since rapid wear seems to be a problem with the linked belts. A cogged belt seems to be my preferred choice for a power tool application when both durability and operating smoothness is required. The Gates also seems to be a bit better than other similar belts in this regard.
Tuffy46
Comentado en los Estados Unidos el 27 de marzo de 2018
I used this on my Craftsman table saw because the other belts seem to develop a out of round problem. This happens when you do not use the table saw for a few months it causes the motor and belt to jump up and down making it hard to cut a thick piece of wood. I bought this belt and twoTB Woods AK2558 pulleys to replace the original dye cast pulleys and this make for a smoother running table saw. And since it is a Gates belt it will last a long time before it need replacement
R.F.
Comentado en los Estados Unidos el 14 de marzo de 2017
Very good belt. The cogged design helped solve the wearing issue I had with a compressor. The compressor's motor had a small diameter pulley and the belt had to go around this sharp bend. I was replacing belts every six months until I started to use the cogged version. Two years and it's still good to go!
Productos recomendados
Mex $499.79
Mex $ 234 .00 Mex $234.00
Mex $271.53
Mex $ 149 .00 Mex $149.00
Mex $1,642.00
Mex $ 755 .00 Mex $755.00
Mex $687.85
Mex $ 357 .00 Mex $357.00