No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Si está buscando un ventilador delgado de 80 mm para refrigeración de PC o como ventilador de repuesto para un dispositivo o componente, entonces estará en el lugar correcto. Este diseño ultra delgado de 80 x 10 mm proporciona un perfil delgado de 10,7 mm, esto lo convierte en la solución de enfriamiento ideal para espacios reducidos.
GDSTIME
Aquí hay más especificaciones para el ventilador 8010:
Salida: 1,2 W máximo, 12 V/0,13 A. Voltaje de funcionamiento: 7 a 13,5 V CC. Conector de alimentación: XH2.54-2Pin
Flujo de aire/presión estática: 18.9 CFM / 0.13 pulgadas H2O | Ruido/velocidad: 25,6 dBA / 2500 RPM ± 10%
Rodamientos de ventilador: La manga funciona a las 35.000 horas. Temperatura de funcionamiento: 14 a 165 °F
Distancia de agujero a agujero: 2.8 x 2.8 pulgadas. (71,5 x 71,5 mm) | Tamaño del orificio del tornillo: Ø 0,5 cm. (Ø 0,45 mm)
Tamaño: 80 x 80 x 10,7 mm. | Longitud del cable de alimentación: 9.8 pulgadas. (250 mm)
Popular en una variedad de electrónica y componentes
Forever Bright
Comentado en los Estados Unidos el 25 de marzo de 2025
Used this fan to fix my mini fridge. Worked great. Only had to swap the positive and negative leads in the connector. Almost silent.
Head Kangaroo
Comentado en los Estados Unidos el 9 de enero de 2025
On the plus side, the fan works fine.FYI, if you are using the fan to replace a bad fan on a Rosewill external hard drive case, the connector is not compatible. You have to cut the connector off of the new fan wires and splice/solder the connector wires from the old fan so that it will plug into the board. It is not hard or long to do. You have to remove all 4 side panels and remove the HDD to change the fan. The fan is held in by 4 screws. It is pretty easy.
Steve O
Comentado en los Estados Unidos el 22 de enero de 2024
UPDATED:I was pleasantly surprised when the seller reached out to me after reading my review. I DID NOT contact the seller or initiate a return as the original review below shows, it was my fault for breaking the fan. Seller sent me a replacement as well as a fan grill even after I told them I wasn't expecting them to.A rare gem in customer service these days. The fan itself still has the same flaws but the customer service makes this a 5/5 experience------------------I know, I know, you aren't supposed to stick your fingers in spinning fans. I had plugged the fan in just to make sure it worked before I installed it in the final destination. It clipped my thumb and one of the fins shattered!Before the fin broke these fans were quite quiet. Now they make some noise because of the uneven cadence due to the missing fin.The fans work as advertised but I have never broken a fan before in the dozens that I have handled, by simply brushing the fin.
MsKim
Comentado en los Estados Unidos el 13 de marzo de 2019
Totally silent. It doesn't appear to move a ton of air. But, it moves it where it is needed as a replacement for the stock fan on an EVGA GTX 650 SC.The fan motor is small and the full heat sink of the video card is now effectively cooled (a previously installed fan moved more air but, was loud, too tall, and the motor diameter too large to cool the center).The connector is a perfect fit.Note: This fan is effective for me in a free air install. Closed case temps WILL effect your results.
user-MF7WUZ
Slow fan.. not recommended
Productos recomendados
Mex $537.02
Mex $ 247 .00 Mex $247.00
Mex $743.95
Mex $ 342 .00 Mex $342.00
Mex $365.46
Mex $ 179 .00 Mex $179.00
Mex $545.85
Mex $ 245 .00 Mex $245.00