No hay artículos en el carro
No hay artículos en el carroLos pernos GM Genuine Parts están diseñados, diseñados y probados según estándares rigurosos, y están respaldados por General Motors. Las piezas originales GM son las piezas originales instaladas durante la producción o validadas por General Motors para vehículos GM. Algunas piezas originales de GM pueden haber aparecido anteriormente como equipo original ACDelco GM (OE).
Douglas Rhodes
Comentado en Canadá el 23 de marzo de 2024
Two are necessary for installing a long/long bolt starter on many GM vehicles, including our 2002 vintage Z28 Camaro. While not as easy to install as the original long/short bolt starter, the long/long is a more robust unit and does fit. Do not attach the wire terminals, or the snap-on heat shield, to the starter before trying to install - There is a plastic flywheel coverplate positioned by the starter and attached by a single 10mm (head) bolt to the lower bellhousing (see left photo above) which should be removed - With the nose of the starter in the coverplate hole, position the starter/cover in place and just start the two long/long bolts - By moving the starter up by hand, the coverplate bolt can also be started into the bellhousing - Remove the two long/long bolts and slide the starter back & down for access to the electrical terminals -Connect the two wires, battery power & ignition start, to the starter studs and the snap-on the heat shield to the starter coil- Reposition starter, coat long/long bolt threads with Locktite Blue and start each into engine block - Tighten both snug then torque in alternating bolt steps. I used 12½ / 25 / 35 ft.lb. (factory spec is 37 but I chickened out)!
Daniel Noriega Quezada
Comentado en México el 22 de diciembre de 2024
Muy buen tornillo, era el necesario para soportar mi marcha de la camioneta Chevrolet.
Robert D.
Comentado en los Estados Unidos el 21 de noviembre de 2024
86K5 Blazer, 6.2 diesel. I found these bolts to be very durable , I will purchase two more since my starter failed, the bolts are gnarled like they should be correct thread and length, do recommend
luvpontiacs
Comentado en los Estados Unidos el 20 de noviembre de 2023
Yes it's expensive. But it's a special starter bolt. It's has a knurled function on it. It should of been included in the new starter I bought.
Larry Jennett
Comentado en Canadá el 20 de noviembre de 2022
I used this product on my chev car/
MYUSVET
Comentado en los Estados Unidos el 22 de octubre de 2020
These are useful bolts. I found mine to be 2mm long then my OE bolts. So I used a very good fitting washer to be sure I wouldn’t damage anything.
Productos recomendados
Mex $402.09
Mex $ 188 .00 Mex $188.00
Mex $271.00
Mex $ 157 .00 Mex $157.00
Mex $285.42
Mex $ 139 .00 Mex $139.00
Mex $762.50
Mex $ 350 .00 Mex $350.00