No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Fuerte compatibilidad
Adecuado para camión eléctrico de campo corto Rc 1/10 Escala Redcat ARRMA GRANITE SENTON TYPHON AXIAL HPI HELION 10SC HSP Wltoys Kyosho Traxxas Slash 2WD 1/10 Camión de campo corto TRA58024/TRA58034-1/TRA58094-1/TRA5807. -64/TrTraxxas Slash 4x4 1/10 4WD Camión corto TRA68054-1
Bobinado de cobre de alta pureza, rotor equilibrado de precisión para un máximo de 22500 RPM, estable, fiable con gran par.
El motor adopta una carcasa totalmente metálica, que es adecuada para varios entornos extremos y es duradera.
Aplicable a todas las condiciones climáticas, el diseño impermeable y a prueba de polvo permite que tu coche desafíe la carretera fangosa.
El ventilador de refrigeración integrado tira del aire frío a través del motor para mantener las temperaturas bajas.
El cable del motor está soldado, por lo que no necesitas soldarlo por ti mismo, fácil instalación y alto efecto.
Exquisito y compacto, fácil de instalar, es el mejor regalo para los entusiastas de los autos RC.
Customer
Comentado en Canadá el 7 de mayo de 2024
Good motor, powerful
David
Comentado en los Estados Unidos el 2 de febrero de 2024
I bought this for my Arrma Granite Voltage after the original motor got too hot and melted the chassis. (I had to replace that as well, ARRMA AR320382 Chassis Set)Between the original brushed motor and this new brushed motor I learned that brushed motors need a 'break in' procedure before use to ensure the best performance and lifetime. (and to keep them from overheating and melting the chassis)I went with the wet method. You actually completely submerge the motor in water, preferably distilled, and run it at about 20% for several minutes. This wears the flat surface off the brushes, making them concave so they make full contact with the armature while keeping the brushes cool and the armature contacts clean.The truck runs very smooth now and we're getting very good battery life.
Vine-o
Comentado en los Estados Unidos el 9 de enero de 2023
I bought this thinking I had read it was a direct replacement for the motor in the 144001, my mistake. In order to fit the motor you will need to shorten the motor shaft and grind or file the flat key portion of the shaft back towards the motor in order to accommodate the pinion gear. After I installed it I broke the motor in by running it at slow/moderate speed for about 30 minutes. IMO this motor has to much power for the 144001 but its loads of fun! On any slippery surface the car is uncontrollable at full throttle. I had to reduce my throttle trim just to get the car to drive in a straight line. If you have the tools needed to make these minor modifications I would highly recommend this motor!
Chad R.
Comentado en los Estados Unidos el 24 de febrero de 2021
Pro: Fitment is correctCon: very poor performance.The sticker on the motor makes this look like a Traxxas motor using the Titan name and the same script for whatever it is. Did a proper break-in. Very disappointed.Update: First, I have returned the motor for a replacement (+1 star). Second, it may be that the timing is off on this motor because it seems to run faster in reverse; that would be a mfg issue. I'll update again when the replacement arrives and has been tested.Update: The replacement motor was the same as pictured and performs as expected. Plus +1 start (now 3) for easy replacement... with correct product.
Jerry
Comentado en los Estados Unidos el 30 de diciembre de 2021
I put it into my Kyosho Outlaw Rampage. It's super torque-y but not to the extent where I would spin out off the line. Powered by a CC Sidewinder SCT on 2S. I could push 3S but then I would have to mess with gearing which I hate, too much on and off parts. So far after 3 battery packs(all 5000mah) this thing is still rocking. I am not sure how people burn out the motor on first use or just 1 battery pack they don't seem to say what battery they were using nor what gears they had in their R/Cs or which chassis type. If you throw this into a short course truck don't hope it can be powered by a 3s with just any gearing. There is the breaking in a brushed motor thing too, but I never did so on any of my brushed motors. IMHO you only do so when you plan to race the motor, all my brushed motors are broken in with just regular driving and bashing I have never had any issues not breaking them in. This motor is worth it's price, there is no such thing as a permanent solution on brushed motors this however could be a long term thus only 4 stars let's see if this will last me 1 year at least. I do doubt it because it's brushed, I had burned many brushed motors even brushless but that was my mistake of running it too hot or wrong gearing.
Productos recomendados