No hay artículos en el carro
No hay artículos en el carroMás información del producto
Agujeros limpios, rápidos y precisos
La babosa se libera en el troquel.
Se puede utilizar en acero templado de hasta 14 calibre
Las unidades de punzón de metal estándar redondas son unidades completas que consisten en perforación, troquel y perno de dibujo.
Knockout de 13/16 pulgadas
Uso con controladores manuales, hidráulicos, carraca o alimentados por baterías.
Los controladores knockout compatibles incluyen:
Cat # 7646 Carro hidráulico y bomba de mano.
CAT# LS100X11A Controlador de batería de 11 toneladas.
CAT# L550L11A Controlador de Knockout operado por 7 toneladas.
CAT# 7704SB QuickDraw Driver.
CAT# 7904SB QuickDraw 90 Driver.
ed mcmullen
Comentado en los Estados Unidos el 14 de septiembre de 2024
After receiving without a draw stud, I exchanged it and the second also did not include it. The description states "complete units consisting of punch, die and draw stud" and the picture shows it, but it does not seem to be included.
Chris Spencer
Comentado en Canadá el 4 de agosto de 2019
I used this punch to punch two holes into my brew pots, as well as a hole through a piece of test steel (metal outlet cover, ~18 ga.). The holes were punched cleanly, with no burrs or any need for filing. I used an adjustable wrench to turn the punch's bolt, and it was all done in less than 30 seconds.
smores
Comentado en los Estados Unidos el 1 de octubre de 2019
This punch worked fantastic for cutting holes to install a HERMS coil in my HLT kettle. It cut through the stainless kettle with very little effort.No burrs to clean out. No worries about drilling too far with a step bit.It is definitely on the pricey side, but the right tools usually are.
Kyle
Comentado en Canadá el 23 de marzo de 2017
Great product, a bit pricey but well worth the ease of use. Used to punch holes in a stainless steel kettle for my craft beer setup.
Kiang45
Comentado en los Estados Unidos el 25 de febrero de 2013
I needed a way to get precise holes in a stainless steel pot. This Worked great, it punched a hole through my 20 gauge stainless with very little effort. I highly recommend this product, especially if you want a clean precise hole. I have used drill bits to do the same work and the holes produced are no where as nice as with the Greenlee Round Punch! I did not have a socket big enough to turn it, but using an adjustable wrench worked just as good. Super easy to use and operate. Highly recommend this to anyone who need to make precise holes in any type of metal.
Productos recomendados
Mex $820.40
Mex $ 434 .00 Mex $434.00
Mex $3,175.97
Mex $ 1,492 .00 Mex $1,492.00
Mex $876.77
Mex $ 447 .00 Mex $447.00
Mex $4,650.49
Mex $ 1,860 .00 Mex $1,860.00