No hay artículos en el carro
No hay artículos en el carro
Comodidad y seguridad --- you get tanto con el nuevo mando a distancia de hangar 9 Glow Plug Adapter. Diseñado para aviones con difícil acceso Glow Plugs, este accesorio permite a los modeladores Energize de la bujía de incandescencia desde una ubicación remota accesible en el fuselaje. Incluye todo lo necesario para instalación, incluyendo 15,2 cm de alambre flexible de silicona y una tapa de goma aislante de bujía de terminal.
Hangar 9
Parte han3025
helena
Comentado en Canadá el 19 de diciembre de 2024
Stays on glow plug , excellent design and quality.
Greg Oliver
Comentado en Canadá el 4 de noviembre de 2023
Good price, and necessary when you have an RC plane with glow engine with the cylinder that is pointed down make it hard to install a glow driver directlyComes longer than required but can be shortend if you can solder and apply heat shrink.
Pinetree
Comentado en los Estados Unidos el 16 de febrero de 2022
These things are great.. I use them on every new plane I put together.HOWEVER, the threaded portion of the jack is barely long enough to pass through a piece of 1/8" balsa.I've bought several of these, and one was slightly longer, but the rest are TOO SHORT to do the job without a bit of frustration and trimming the inside of the fuselage.Once you get to the 16" and larger props, I'd consider using one of these, just plan ahead where you'll be placing the jack.
Sean D
Comentado en los Estados Unidos el 20 de junio de 2021
This is what I’ve been waiting for! Don’t get the Dubro or the Sullivan, or the MPJ. Get this one. It’s boot actually fits on a glow plug without a hassle and clips in very nicely. I was hesitant at first, but decided to try yet another remote igniter setup from a different manufacturer. I’m glad I did. I will buy more for sure. In fact, I may buy a few and put them away for later.Once you install everything, I highly recommend soldering and heat shrinking the brass clip that is on the glow plug lead. Installation and soldering and heat shrinking took about 10 minutes from the time I opened the package to the point of testing.
Porsche_Bill
Comentado en los Estados Unidos el 13 de diciembre de 2020
I needed the fittings for my float plane. Yup chopped wires/re-soldered. and used the hardware for a great install.The glow plug connector fits like a glove on my Magnum 52 4S. I mounted the female phone plug on the fuse and the male end is a pigtail to connect the removable wing with engine pod. The back side of the plug goes to my glow driver module.Clean install and that's how we model Folks!!
Productos recomendados
Mex $301.87
Mex $ 141 .00 Mex $141.00
Mex $262.78
Mex $ 152 .00 Mex $152.00