No hay artículos en el carro
No hay artículos en el carroHoja PEI texturizada de doble cara de 235 mm x 235 mm-FugaCity PEI Kit de placa de construcción con acero de resorte PEI de doble cara y calcomanía magnético para impresora 3D Creality Ender 3 /Ender 3 S1/Ender 5
Salvador Joaquin Carrera Lopez
Comentado en México el 4 de enero de 2025
La cama magnetica cuenta con su iman adherible y su placa PEI, estan exactos para una ender 3v2, viene bien empacado y se siente de muy buena calidad, super recomendado!
Mack Kidd
Comentado en los Estados Unidos el 9 de diciembre de 2024
No more scrapping or prying to remove printed items. No more glue or hair spray. The magnetic base holds the metal build plate firmly and the magnetic base is held on the bare base plate with a peel and stick adhesive and this adds an extra feature of not having to use hold down clips or screw clamps. When heated to operation temperature the filament adheres very well to the PEI plate but once the plate is cooled the printed item will lift off with minimal effort. The PEI plate can easily be lifted off and placed in a freezer if needed but I haven't had to use that procedure. Yes, this build plate will spoil you.
George W. Hodson III
Comentado en los Estados Unidos el 30 de noviembre de 2024
Works wonderful
Jordan
Comentado en los Estados Unidos el 25 de noviembre de 2024
Prints stick to the surface amazingly well when printing, yet are removed extremely easily when they are done. If you need a replacement PEI sheet or are looking to upgrade, you can't go wrong with this one. Installation is stupid simple. Worth every penny.
Nevada Woodchuck
Comentado en los Estados Unidos el 17 de diciembre de 2023
My 3D printer came with a glass bed, and I found that it was difficult at times removing the prints. Ordered this and am glad I did. Being flexible you can remove a print almost immediately after it is finished printing and start another one while things are still warm. I clean it after every couple of prints by spraying isopropyl alcohol on it and wiping it off. I'm also able to remove any print residue by scrubbing it with a brush then cleaning it with the alcohol. Well worth the small investment.
Bryan
Comentado en los Estados Unidos el 22 de noviembre de 2023
This was a major step up from the glass bed I had been using for nearly 2 years. I've had zero adhesion issues, parts are easy to remove and it's lasted through 100s of hours of printing without showing a single sign of wear. The edges are a bit rough though and often snag the microfiber cloth I use for cleaning the bed between prints. Not a deal breaker, just something that could have been taken care of in seconds at the factory.Well worth the purchase.
Productos recomendados