No hay artículos en el carro
No hay artículos en el carro Ángulo máximo: 180° en total, cada dirección 90°
Dimensiones: 22,8 mm x 12,2 mm x 28,5 mm.
Par de parada: 1,8 kg/cm (4,8 V) 2,2 kg/cm (6 V).
Rango de temperatura: 0 grados a 55 grados.
Velocidad de funcionamiento: 0.1 seg/60 grados (4.8 v), 0.08 seg/60 grados (6 v).
Ajuste de banda muerta: 5 microsegundos.
Voltaje de funcionamiento: 4,8 - 6 voltios.
Tipo de motor: motor sin núcleo
Longitud del cable del conector: 260 mm
Peso: 13,4 g.
El paquete incluye:
5 servos mg90s.
Bri
Comentado en los Estados Unidos el 19 de marzo de 2025
Much better replacement for cheap E-flite servos. Good buy
Alex
Comentado en Canadá el 17 de agosto de 2024
4 out of the 5 in the pack worked and the last one didn't even seem like it received power. The others work fine and to the specs listed but I can't give this pack 5 stars seeing as how I've only got 4 usable products out of 5 that I've paid for.
KT
Comentado en los Estados Unidos el 14 de mayo de 2024
Great servo, only thing is the case is 2mm deeper than other micro servos, so it touches the suspension links. But they were not sold as scx24 servos, I just know there are a lot of scx24 builders that may want these. Over all they work great.
MoYeniRo
Comentado en los Estados Unidos el 26 de febrero de 2024
these "Metal Gear" Micro Servos are great for projects requiring higher torque where plastic gears might strip. They worked great in my project to make a smart plunger stop lift for a water tank! They work using 5 Volts and could be wired directly to an ESP32. They each were packaged with 3 different lever arms and mounting screws to get the project going!
Tampico
Comentado en México el 3 de noviembre de 2022
Magnífico
RT
Comentado en los Estados Unidos el 15 de abril de 2022
All five tested fine when arrived. As with the other MG90S servos there's only about a 90 degree range and an expander or mod is needed to get the 180 degree range. No load motor noise varies slightly between the five servos.Turning them by hand they do spin endlessly in either direction. But they function fine as a steering servo when commanded by a controller.Top output gear/spline has a lot of up and down play. As read from a review from another listing if feels like there's no top bearing. I've added a stock photo of either the original MG90S or an older better clone where you can see how tall the brass intermediate gear and final gear are and compare it to the shorter height gears in photo I took for the review. This has made the smooth shaft much longer and allows for the play. One can fix this by shimming it.Pinion gear from motor and immediate gear are plastic while the rest is metal. Pretty sure at this point all MG90S clones are like this now. Top sleeve bearing as expected. They didn't skimp on the grease for the plastic gears to the point they've leaked out of the case a bit too.These are fine for my small scale surface RCs steering servo. I wouldn't use it on anything important.
Productos recomendados
Mex $402.51
Mex $ 201 .00 Mex $201.00
Mex $229.00
Mex $ 125 .00 Mex $125.00
Mex $465.03
Mex $ 237 .00 Mex $237.00
Mex $802.90
Mex $ 425 .00 Mex $425.00