No hay artículos en el carro
No hay artículos en el carroBengalas y guarniciones. Se convierte rápidamente. Alimentación tipo tornillo. Ideal para su uso en cuartos cerrados. Incluye dos barras para cubrir 9 tamaños. Los adaptadores giratorios y el cono de flaring son de acero endurecido, acabado cromado para facilitar su funcionamiento. Yugo de acero forjado autocentrado, deslizable. Incluye estuche de herramientas. Peso: 3.5 libras. Bengalas de 1/8", 3/16", 1/4", 5/16", 3/8", 7/16", 1/2", 5/8" y 3/4" O.D. Incluye 5 adaptadores Swage para 7 tamaños de tubo: 3/16", 1/4", 5/16", 3/8", 1/2", 5/8", 3/4" O.D.
Jorge
Comentado en los Estados Unidos el 4 de enero de 2025
Gran desilusión, en las fotos publicadas dicen que es fabricación USA, lo que me llegó es imperial pero es de fabricación Tailandia
上田伸也
Comentado en Japón el 2 de marzo de 2023
知り合いが写真と同じもの。ケースに入っている配置、USA製というのが同じなので、購入したが、写真と違うものが届いた。評価にも値しない。
Squirrel!!
Comentado en los Estados Unidos el 6 de octubre de 2020
I really just needed this for some 3/8" copper repairs in my RV, and it did the trick perfectly. I had purchased a cheap brand first because it had relatively decent reviews. But it scraped up my tubing, wouldn't clamp down fully even then, and created an oversized swage with a gap I was pretty sure solder wouldn't be able to fill properly. Sent that back and picked this one up, and I noticed right away the increased weight between the two. The vice is much smoother and of higher quality material, didn't crimp my tubing excessively, and performed a very snug fitting swage. I would have probably preferred a tiny bit more wiggle room, but once the copper is sanded, it'll probably be perfectly fine (soldering is on tomorrow's list). I love that it's made in the USA and still cheaper than the higher end brands, but seems well made and in good tolerances.EDIT: Finished soldering and flaring 2 of the lines for a flare nut, tightened up, leak checked, and I'm in business again.
WhitetailHunter23
Comentado en los Estados Unidos el 11 de diciembre de 2016
I bought this because I needed a good swage kit. I don't like using swage punches. I have a really nice hilmor orbital flare kit but it doesn't come with the swaging capability so I bought this. Overall this imperial does the job it needs to do. I have only used it on 3/8 copper so far and I noticed that when I try to fit the pieces together it is pretty tight. I have used other swage kits that swage a little bigger and not so tight, but this is ok. I find it hard to clamp my piece without damaging the outside too much. I'm not a big fan of the way the clamp is set up but it works pretty good in the end. This imperial does what it is supposed to do and I can't complain too much about that. I was debating this over the Bacharach swage kit and I wish I would have gotten that one instead. I have used the Bacharach before and I like it better. As far as flaring goes, it is no where near my hilmor for flaring. I strictly neeeded this for swaging and I would much rather flare than swage anyway. If you don't want to break the bank this will perform your swaging needs however I think there are better ones out there
Productos recomendados
