No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Carga sin problemas
Giro de 360°
Super Stable & Never Fall
Brazos y pies regulables
Duende
Comentado en los Estados Unidos el 28 de febrero de 2024
This was easy to install and use. I did have another vent-clamp style, but they made the backside of it so complex that I ended up accidentally breaking it. I don't like the type that suctions onto the dashboard since they tend to leave marks behind and the suction always seems to give out sooner or later. I wanted one with a mechanical connection. The I got the kind with a magnet since my phone's case had a ring with a magnet on the back, but it was too weak and the phone kept sliding off. This one is the best of them so far. I did put in on teh vent to the left side of the wheel since all the vents around my center made my phone cover some area of the center control panel that I needed to see. So even thought it' son the small round vent, it's steady and holds my phone well in it's somewhat thick case. Just put it in and squeeze teh sides together. The to release it, just push the button on the right side under the side clamp and it releases easily. Great item! Recommended!
Sergio
Comentado en México el 19 de noviembre de 2024
El producto venia incompleto, me tarde mas en abrir en paquete que en devolverlo ya que no venian los ganchos para asegurarlo a las ventilas del AC
Jeff L.
Comentado en los Estados Unidos el 8 de enero de 2024
The vent adapter has the same "hook on the end of a long stick" setup that it seems all the good ones do. You fasten it by turning a wheel to retract the hook and pull it tight against the back of the air vent slat. There's also an adjustable pad at the bottom, to help it hold the angle. In my car (a Civic), it was not necessary, since once the holder was tightened against the vent, the slats were "frozen" in one position. This turned out to be a good thig, since if I had needed to put it down to rest on the dash, it would have impinged on the hazard flasher. (The dash of a Civic doesn't exactly have wide open spaces.)The phone holder platform has the typical 2 arms with foam pads on the sides to hold the phone securely. This worked very well with my phone. The release button, on the right-hand side of the platform, works well; when you press it, the arms slowly release the phone so you're less likely to drop it.Like almost all of these things, for installation you need to remove the ring around the round connection port and slide it onto the mounting attachment, then press the platform on, then screw the ring back on, set the platform to the angle you want it, and tighten the ring. It's not super easy, though this one isn't any more difficult than others, and you only need to do it once. The included instructions, in English, are better than most, if you don't already know how. The locking ring isn't too big, so if you don't have strong hands or your phone is on the heavy side, you might want to get someone to help you tighten the ring enough to hold the angle, or use a strap wrench. Again, you should only need to do it once, so it's not as bad as it might sound.Once it's set up, it holds the phone securely, and it's easy to get the phone in and out with one hand.
Bob in Boston
Comentado en los Estados Unidos el 7 de diciembre de 2023
It is with hard-won and expensive experience that I can say THIS CELLPHONE HOLDER IS THE BEST I HAVE EVER USED!I have tried dozens of cellphone holders over the years – and still have a box of them in the basement. This one is the best. Normally I wouldn’t get this exuberant about a part for my car, but after spending so much money over the years and being frustrated with the dozens that I’ve tried before, it is great to have a device that finally fits right and solves the problem.-- SECURE FIT: It locks onto the vent securely – no wobble, no shaking, no moving around, no flying off on hard braking, no loosening, and no need for readjustment or fidgeting. It holds the phone securely and has a stable attachment to the vent.-- Flexible placement: The mounting and locking system works on a wide range of vent sizes, designs and placements.-- Good fit with the phone. The holder does not interfere with access to the buttons on my Samsung Galaxy phone or my wife's iPhone. That was an issue with some holders, but the fit here is perfect.-- EASY TO PLACE: It took a few minutes to get the ideal fit. Watch the video in the Amazon product listing and it will be clear how to use it.Really – this is one great cell phone holder.I’m using it with a Samsung Galaxy phone in an Audi A6 and also tested it with an iPhone in a Subaru Outback.
Jess S.
Comentado en los Estados Unidos el 26 de diciembre de 2023
Firstly, this does fit my big phone and holds it well. It is easy to put your phone into and tightens well around it. However, the button to release it is in an awkward location so removing it is not super easy. Also, the stability is super lacking. This hooks over your vent instead of being a vent clip. Since my phone is relatively heavy it flips side to side and is not very stable while driving. Kind of a pain to have to fix it all of the time while driving and using the GPS. But, it does work...
Mahmoud Alkhatib
High quality, easy to fix, good price
Productos recomendados
Mex $406.76
Mex $ 211 .00 Mex $211.00
Mex $415.33
Mex $ 224 .00 Mex $224.00
Mex $139.00
Mex $ 80 .00 Mex $80.00