No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Mrhandymanblue
Comentado en los Estados Unidos el 30 de abril de 2025
Installed in my 09 tahoe and it was a perfect fit, really good quality product
Joshua
Comentado en los Estados Unidos el 6 de octubre de 2024
Motors mounts and transmission mount seems to be decent quality. The long run will tell with that. Bolt hole in all the mount lined up and heat shield lined up perfectly.Not a guide, but sharing my experience.Transmission mount - Pretty easy to do. Take two nuts off bottom of the mount that's under the cross member. With a jack supporting the transfer case, take out two bolts on the upper portion of the mount to the transmission. Jack up transmission just enough to slip mount out. Reassemble in reverse order with new mount.Motor mounts - I opted to go through the wheel wells.Driver's side - I started with this side. Jacked up vehicle and placed on jack stands. Took front wheels off. Took wheel well liner off. Remove heat shield from exhaust manifold. Mark steering linkage and remove. Remove the 3 bottom bolts to the motor mount then raise engine up. Take off the 4 bolts that are securing the motor mount to the block. I had to bent old heat shield around a little so I could sneak it out of the engine bay. Installing the new one, I had to bend the new head shield a little in various ways to get it to slip in. Reassemble in reverse order of disassembly.Passenger side - fairly similar to driver side but a few key differences. I couldn't sneak it out. I had to take off the 2 nuts off and take the mounting plate off the motor mount on both the old and new motor mount to be able to get it in and out, and Reassemble the new one inside the engine bay. Getting the bolts back in was a pain in the butt on this side.Everyone's experience may be different, specially with many different set ups and approach of doing this. Make sure you have multiple length extensions and universal joints.Not a guide, just sharing my experience. Glad everything fit perfect alignment wise.Picture of old mount posted.
james
Comentado en los Estados Unidos el 31 de octubre de 2024
I put this on my 2010 yukon with 5.3 liter engine with 4x4. The product was good quality but the installation was a nightmare. It would have been a nightmare with any mount I bought. I should have removed the steering shaft which I found out later is a two piece shaft. In a 2 wheel drive that's not necessary but in the 4x4 it saves so much time and aggravation.
Travis
Comentado en Canadá el 17 de junio de 2023
Thank you ive replaced this 3 times your was the only one that came with a heat shield.
Eler
Comentado en Canadá el 11 de noviembre de 2023
I have 2007 chevrolet avalanche, 5.3 so this engine mount fit perfect. Took me 1.5 hours but I'm a mechanic, did it on my drive way. The new heat shield with the part is a plus no one else sells it this way that's why I purchased from you. thank you.
Productos recomendados
Mex $9,020.67
Mex $ 1,881 .00 Mex $1,881.00
Mex $1,477.59
Mex $ 738 .00 Mex $738.00
Mex $229.36
Mex $ 121 .00 Mex $121.00
Mex $805.53
Mex $ 443 .00 Mex $443.00
Mex $822.90
Mex $ 403 .00 Mex $403.00
Mex $544.58
Mex $ 255 .00 Mex $255.00