No hay artículos en el carro
No hay artículos en el carroStan L.
Comentado en los Estados Unidos el 16 de febrero de 2025
I was going to give it a 1 star because it kept on turning on by itself in bathroom. Then I found out it is NOT made for small rooms ilke a bathroom or closet. So I moved it to my 2 car indoor garage and it works AWESOME!!!!!
Customer
Comentado en los Estados Unidos el 18 de enero de 2025
Easy to install. I needed 4 wires coming out of the sensor to match how my old sensor was wired. Most sensors come with 3 wires.
Customer
Comentado en Canadá el 15 de junio de 2023
I just installed two of these at the request of the owner of a new restaurant. One in the men's washroom and one in the women's washroom. Each is switching a 0.5 ampere fan motor(60 watts) and 100 watts of LED lighting. I cranked the sensitivity to the max and adjusted the on-time to approximately 15 minutes or so. So far they are working perfectly. It has been 6 weeks and no sign of fault. Everybody says they work great. The response time to trigger is a hair to slow but totally fine. As a backup plan, if these fail, I installed 24 volt lines to install the low voltage version with solidstate relays. Being a commercial space, I can not afford to have these fail. I did not warranty them, nor the fans because anything with a motor or sensitive electronics is deemed to fail at some point in time. What I did do is give the client a back-up plan. Anywho, these things are working great.
ARTEK Electrical Services LLC
Comentado en los Estados Unidos el 6 de febrero de 2021
This product is an exact replacement for the IR motion sensor I installed in my home in 2003. I purchased original Leviton units from local electrical supplier. Seems like 2016 they started to fail. When I rebuilt my 200+ year old home I made electrical provisions to control the lighting in each room, and or area. Worked great. I'm gradually replacing, and after six months of use, [gradually replacing them] so far so good. The green LED behind the bezel seems brighter [indicates motion detected]. One setting for daylight [I don't use-turned down to disable], and the time delay takes a little messing around till you get it where you want it. So don't put the ladder away right away. Be patient, once you have it dailed in where you want it, it has stayed consistent. Also remember, it's IR sensor, so radical temperature variation will initiate sensor. I have ductwork that will blow heat/ cool, so rarely that initiates. The physical attributes resemble a smoke detector in the ceiling. Be aware also if using this with a 1G old work box the sensor does not completely cover. When we sheetrocked covered most of the opening then cut out min opening. Don't know what Leviton expected electrician to use for box to make it finish nicely. Overall really reliable.
Michael W
Comentado en Canadá el 10 de noviembre de 2021
Very happy with this product, works perfectly in my 400-500 sq foot garage
Productos recomendados