No hay artículos en el carro
No hay artículos en el carroMarlon G. Betancourt
Comentado en Canadá el 23 de marzo de 2025
Only reason I am not giving it a 5/5 is because the installation instructions are a bit confusing. What I thought would be a 30 minute install or less became an hour endeavour. That said very sturdy and a bit heavy.
rkruz
Comentado en los Estados Unidos el 5 de julio de 2024
No se pudo cargar el contenido.
Dave VanHoek
Comentado en Canadá el 19 de julio de 2024
This was a nice quick and easy install that didn’t require any drilling on a Wrangler JKU. It feels quite sturdy and doesn’t rattle at all. You can open both shelves or leave the top one down if you need the height on the bottom one. Doesn’t intrude into rear storage.
Craig in Queens
Comentado en los Estados Unidos el 19 de diciembre de 2024
Excellent product for the price but you have to throw away the instructions if you have a JL.Abandon the standoffs. Those are the aluminum collars that are supposed to provide spacing between the painted body and the tray. There's absolutely no reason to use them and they just increase the opportunity of you screwing up. Instead, remove the rectangular top portion design for the factory rail system. You can put that away as you don't need it at all and no reason to drill through it. However you do have to make two small holes directly opposite the two bottom outermost threaded standoffs on the door. This is pretty easy to do. Put the aftermarket screws in the holes to almost flush level with the panel. Just have them stick out a quarter of an inch. Then coat the heads will you put the screwdriver in with thick grease. Just a dab on each one. You're not going to use it for lubricant. Now position the top part of the black plastic panel you pryed off. Make sure it's perfectly centered. Then swing the bottom down and contact it to the screws. It should not be enough to clip it in as the screws should be preventing it. Now remove it again and you should have two grease marks on the back of the panel from the screw heads. That's where you're going to drill. Drill a 3/8 hole from the inside out right in the center of those Grease marks. Remove the screws and clean them up. Now put the black plastic panel in without that rectangular insert you discarded. Now install the Trey using the four bolts washers and lock washers. You will be able to get the tray flush up against the plastic interior panel. It may be a little difficult to get the bottom screws because of the angle so I recommend maybe using an allen head at the end of a quarter inch driver extension? Either way you can get it in there. Don't torque them down too tight or you'll crack the plastic. That should be it see the pictures. Very flush and professional looking.
Führmann
Comentado en Alemania el 14 de octubre de 2024
Jeep Wrangler Jk 2011 70th EditionKofferraumklappe geht wegen dem Subwoofer nicht zu. Musst ihn ausbauen.Montage selbsterklärend und relativ einfach. Robustes Material. Die Schnappverschlüsse neigen leider zur Schwergängigkeit, Gefahr die Finger zu quetschen. Die Fangseile verklemmen sich komisch zwischen dem Tisch und der Halterung. Verbesserungspotential.War leider über der Rücksendefrist, sonst hätte ich ihn nicht behalten.
Productos recomendados