No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Fuente de alimentación LED impermeable:
La fuente de alimentación impermeable de 60 W/2.5 A es una fuente de alimentación de voltaje constante (24 V), que es compatible con una tira de luz de un solo color o RGB, cadena de luz, enrutador inalámbrico, ADSL Cat, HUB, interruptor, cámara de seguridad, altavoz, receptor, amplificador, fuente de alimentación de audio/video. Ten en cuenta que la potencia total de tiras de luces LED u otros artículos no debe exceder la potencia máxima (60 W) de este adaptador.
Seguridad:
Protección automática para cortocircuito, sobrecarga, sobrevoltaje, sobrecorriente, sobretemperatura. Tipo de protección: Modo hipo, recuperación automática después de quitar la condición de falla.
Características:
Fuente de alimentación de estilo voltaje constante y entrada de CA universal/rango completo. Enfriamiento por convección de aire última intervensión y totalmente encapsulado con nivel IP67. Prueba de combustión 100% de carga completa. Pequeño volumen, bajo peso y alta eficiencia. Protecciones para cortocircuitos, sobrecarga, sobrevoltaje y sobretemperatura.
Especificaciones del producto:
Entrada: 90-265 V CA 50-60 Hz. Salida: 24 V CC 2.5 AWattage: 60 W. Temperatura de trabajo: -20 ℃ a +60 ℃. Humedad relativa de trabajo: 20%-90% RhDimensiones: 6.6 x 1.9 x 1.35 pulgadas. Resistente al agua: Eficiencia de entrada IP67: 88 %. Peso: 1 libras
Connecticut Fan
Comentado en los Estados Unidos el 17 de marzo de 2024
This power supply is a well-made heavy duty unit. 60 watts at 24 volts is equal to 2.5 amps, so it can power a lot of LEDs.Kudos to the manufacturer for including a flyer with specs for the full range of products; they have designs for many different wattages. They also include information about heat, since the aluminum housing is a heat sink to keep the unit cool. You shouldn't touch it when operating as it is hot. This is not a table-top unit! Place it in an area with ventilation but out of the way so it isn't touched or handled.A first-rate unit that even includes solderless connectors to attach to the LED light. Five stars for sure.
Esteban
Comentado en los Estados Unidos el 4 de febrero de 2024
I purchased two 60W 24v (cv) PSUs to drive Athom WLED controllers, one for under cabinet lights and another for a small pantry. For the under cabinet lights I snipped off the PSU plug and direct wired the PSU in a shallow junction box I had under the cabinet. I mounted the PSU to the bottom of the cabinet and it’s working great. No complaints.The Pantry one I could plug into an outlet and it works, but it does have an annoying coil whine. I measured the current draw at 0.65A for 15’ rgbcct strip, so it’s under 16W and not overdriving the supply. It’s too much work to swap them out to test if the issue is isolated to one PSU in same config, and given location the whine isn’t too bad.I’m guessing any PSU is going to have possibility of coil whine - I read about people with meanwells having same issue, just roll of dice, so am not ready to say anything too negative yet.I have more LED projects and will likely buy more of these power supplies. They seem to be of solid construction, are relatively compact, and so far are working fine. They also shipped quickly. We’ll see if more have same issue.
ModernFamily
Comentado en los Estados Unidos el 21 de febrero de 2024
Use these to power LED strip lights outside, protected in an outdoor enclosure just in case. One is powering a single controller and about 30ft of very dense led strips with no issues.
Thomas J Havard
Comentado en los Estados Unidos el 29 de enero de 2024
I used this to finish a back lit address sign my wife made. It is outside, but inside an enclosure. So it's not in direct weather, but still damp. It had worked great for the last month.Time will tell if it holds up.
DKMI
Comentado en los Estados Unidos el 6 de mayo de 2021
This is the third transformer I’ve purchased for my post light. I’ve always replaced them with the kind that’s a heavy block with prongs on it for the outlet. The problem is, I sometimes need to unplug it, but I have nowhere to set it safely. This certainly fixed that problem. A few small anchors and this thing is secured to the wall. No dropping or getting caught on things. The housing is metal. It really feels like a quality item. It took me 20 minutes to mount and and connect the wires.On a side note, I also got an Alexa enabled smart outlet. It was less expensive than replacing the photocell in the post. I have Alexa turning on my post light at dusk and off at dawn. If I ever install landscape lighting, I will do the same thing.I can’t comment on the longevity of this transformer, but I doubt I’ll ever need to replace it.
Productos recomendados
Mex $221.00
Mex $ 130 .00 Mex $130.00
Mex $1,284.33
Mex $ 552 .00 Mex $552.00
Mex $4,641.73
Mex $ 1,881 .00 Mex $1,881.00