No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Especificaciones:
Rango de temperatura: -65 ~+165 ℃ (cable PE -40 ~+85 ℃)
Voltaje de funcionamiento: 335 V máximo. Impedancia: 50 ohm, baja pérdida
Rango de frecuencia: DC ~ 6 GHz
Resistencia de aislamiento ≥ 5000 MΩ
Vibración: MIL-STD-202, Método 213
Contacto central: ≤ 3 mΩ, contacto externo: ≤2mΩ
Durabilidad (apareamiento) ≥500 (ciclos)
Materiales: cobre puro y niquelado
Kit de adaptador SMA a N 4 conectores tipo
Conector 1: SMA macho a tipo N macho
Conector 2: SMA macho a hembra tipo N
Conector 3: SMA hembra a macho tipo N
Conector 4: SMA hembra a tipo N hembra
Customer Review
Comentado en los Estados Unidos el 20 de marzo de 2025
I am returning the defective meter that these were purchased for. Because the meter is not working as expected, I have no use for these adapters.These items are the correct ones for the SWR meter I purchased. There is some looseness in the fittings, so I am unsure of long-term durability. Also, unsure whether outdoor use would be appropriate.
Alaska Mike
Comentado en los Estados Unidos el 21 de febrero de 2025
Extremely handy to have on hand for handhelds and my SWR meter seem to be very good quality happy with my purchase
Tuco 2049
Comentado en los Estados Unidos el 23 de diciembre de 2024
Well if you have reason to believe that an extra SMA or UHF connector stacked up here and there has little effect on your power and SWR readings. Think again! Regardless of what people may say or do in videos on u Tube. They are not telling you the accurate facts. Excess hardware like BNC pigtails and adapters. Each connector has a unique resistance. All which appear to skew and corrupt readings. My point here is to share my going to every length not to use a daisy chain of fittings because the right combination was not provided with my SWR meter. The before and after photos speak for them selves. While the first photo and readings are not way out of spec at this chosen test frequency. The power to SWR ratio trade places. The power goes down while the SWR goes down. So smaller numbers in power can’t be ignored. The drop in SWR’s translates to more of what we do have is actually going out in the transition.This equates to less noise and better reach.Also less stress on the radio and less emissions leaking at the points of use. Rather than the tip of the antenna.Less is more also a closer representation of how it will behave when the meter is not present.
Raymond
Comentado en Canadá el 10 de diciembre de 2024
merci
snaggy
Comentado en Canadá el 23 de junio de 2022
Nice heavy well built adapters. Recommend.
Productos recomendados
Mex $1,272.00
Mex $ 636 .00 Mex $636.00
Mex $4,330.47
Mex $ 1,732 .00 Mex $1,732.00
Mex $226.72
Mex $ 131 .00 Mex $131.00
Mex $351.00
Mex $ 164 .00 Mex $164.00
Mex $205.00
Mex $ 116 .00 Mex $116.00