No hay artículos en el carro
No hay artículos en el carroKent S. Kokko
Comentado en los Estados Unidos el 28 de marzo de 2025
The 1/4” hex slots are very tight and makes removal difficult. I have to use pliers to remove the bits. Not worth the trouble so I scrapped it in favor of a magnetic strip bit holder
Elijah Gore
Comentado en los Estados Unidos el 6 de abril de 2025
Neat little organizer
Andres Byzan
Comentado en México el 13 de mayo de 2024
Excelente
Michael Haire
Comentado en los Estados Unidos el 24 de marzo de 2024
The holder looks to be 3D printed. It has a magnet on the bottom to hold to the side of a tool box which works well.The bits fit snuggly in the holder and don't easily fall out but not so hard you can't pull them out.The holes are quite close together so unless you have tiny fingers you probably can't utilize all the spaces unless you keep a needle nose pliers handy.
E. Scott Eastman
Comentado en Canadá el 7 de octubre de 2024
Appears to be 3D Printed in TPU. Contained a few printing defects. Tolerance is inconsistent. Some holes where quite to difficult to insert a bit, others didn't hold on and the bits just fall out. 3D printing is not the right production method of this type of product. Would not recommend.
Adam VandeHei
Comentado en los Estados Unidos el 27 de octubre de 2024
Strong magnetic base and snug, but not too tight of bit holders.
Productos recomendados