Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

plumbcraft baño completo Drain Kit de reparación, Kit de reparación para fuga de baño, Blanco

Envío gratis en pedidos superiores a Mex $600.00

Mex $456.09

Mex $ 246 .00 Mex $246.00

En stock

1.Nombredelestilo:Instalación De Basurero


Acerca de este artículo

  • Este kit proporciona instalación universal.
  • Se puede conectar a la pared o al suelo.
  • 15 piezas para múltiples opciones de instalación
  • Hoja de instrucciones detallada incluida
  • Easy to install;Este kit proporciona instalación universal;Este kit proporciona instalación universal


Kit completo de reparación de desagües de baño. Fácil de instalar. Instalación universal. Instale en la pared o en el piso. 15 piezas para múltiples opciones: (1) 1 1/4 X 7 TUBO DE PARED, (1) 1 1/4 J-BEND, (4) 1 1/4 arandelas, (4) 1 1/4 tuercas, (1) 1 1/2 X 1 1/4 arandela. (1) 1 1/2 tuerca, (1) 1 1/4 x 12 tubo de extensión, (1) 1 1/4 x 5 tubo, (1) 1 1/4 hembra J-bend.


Customer
Comentado en los Estados Unidos el 30 de marzo de 2025
Had every possibility hangup solutions in this kit for us to install up and running with new sink, dishwasher, garbage disposal and countertops. Also went with new housing watree and drain and hookups. Only issue we had was lengthening the new faucet flex lines to under sink valves already installed. This covered everything and no extra runs to hardware store. Very pleased.
Don
Comentado en los Estados Unidos el 25 de marzo de 2025
Decent quality kit that has a lot of parts when you’re redoing or moving a sink in your kitchen or bathroom. I wish they were a little bit heavier duty, but otherwise they are good.
Luis Rosario
Comentado en los Estados Unidos el 4 de abril de 2025
Not bad pretty damn good actually. I had to cut one end due to length but No complaints.
Francisco Puertos Pérez
Comentado en México el 11 de marzo de 2022
Hasta ahora funcionando bien, pero los cinchos de plástico que trae no sirven, son muy chicos por lo que tuve que comprar abrazaderas.
Daniesan
Comentado en México el 4 de junio de 2021
Funciona bien para ajustar las tuberias
Customer
Comentado en Canadá el 15 de enero de 2021
I bought because of lock down from covid to make sure I had all parts needed for hook up. It didn't come with all the parts needed lol I used on piece from the kit and had to go to store for other parts. Way cheaper and easier to go to the store after you get unit for the couple pipes needed for hook up. I don't recommend this kit
Stephen Throop
Comentado en los Estados Unidos el 17 de noviembre de 2019
I don't know why the plumber chose a chrome-plated brass S trap for the bathroom sink. The zinc can leach into the drain water, rotting the brass until it crumbles.When mine crumbled, Amazon had a plastic one delivered within 36 hours. It seemed flimsy, but when I looked into it, I was pleased. It seems to be polypropylene. It doesn't need to be as thick as PVC because it's less brittle. It can't be painted or glued because almost nothing will stick. Maybe that will keep a trap free of gunk.I thought the included extension complicated the installation needlessly. I changed my mind when I went to insert the pipe into the floor connection. Pushing the extension in made the pair of pipes shorter so I could get them under the sink. Then I extended it to the height I needed.To avoid persistent leaks due to deformed pipe ends or washers, I left all the nuts a little loose so I could align one connection by turning or sliding another. When all looked well aligned, I turned the nuts hand tight. Then I put a coffee can under the trap. After 72 hours, the pipes and the can were still dry. Success!On the old brass trap, the bottom of the upper bend was 2.5” above the top of the bottom bend. That’s typical of S traps I’ve seen. Pulling the water out of the trap would require enough suction to lift the water 2.5”. The PlumbCraft trap is much taller. The bottom of the top bend is 5” above the top of the bottom bend. That means it would take twice as much suction to empty the trap.I’ve never seen a trap that went dry that way, but I have smelled sewer gas from unused showers, sinks, and toilets after evaporation dried traps. The PlumbCraft holds more water than others I’ve seen, so it would take longer to dry up from disuse. It would probably be similarly advantageous when installed as a P trap. I don't know why they all aren't made this way.
Zac
Comentado en México el 14 de agosto de 2017
Justo lo que necesitaba, cubre todos los elementos requeridos para una fácil y por ende Rápida instalacion. Muy buena compra
Productos recomendados

Mex $1,893.78

Mex $ 927 .00 Mex $927.00

4.9
Elegir

Mex $2,378.00

Mex $ 974 .00 Mex $974.00

4.8
Elegir

Mex $3,293.81

Mex $ 1,449 .00 Mex $1,449.00

4.5
Elegir

Mex $8,023.26

Mex $ 1,881 .00 Mex $1,881.00

4.9
Elegir