Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

Prostormer 3500 GPH Bomba de agua sumergible limpia/sucia de 1 HP con interruptor de flotador integrado para piscina, estanque, jardín, bodega inundada y riego

Envío gratis en pedidos superiores a Mex $600.00

Mex $954.71

Mex $ 429 .00 Mex $429.00

En stock

1.Nombredelestilo:1/2hp


Acerca de este artículo

  • Consejo 1: cuando empieces a usar la bomba, debes sumergirte en el agua en un ligero ángulo permitir que el aire rente escape.
  • Consejo 2: el dispositivo no es adecuado un funciomiento continuo (por ejemplo,o bomba de recirculación para enques). Este tipo de uso acortará sustancialmente la esperanza de vida de la bomba.
  • La bomba de sumidero Prostormer de alta potencia de 1HP utiliza potencia de 1HP, que es más eficiente que la bomba de sumidero ordiria de 3/4HP; la calificación máxima de 3500GPH aborda cualquier trabajo de drenaje en una fracción del tiempo.
  • Taños de salida múltiples: 3 salidas de diámetro diferentes (1 pulgada, 1-1/4 pulgadas, 1-1/2 pulgadas) para adaptarse a mangueras de diferentes taños según sea necesario de acuerdo con el caudal. Cuanto mayor sea el flujo, más ancha debe ser la salida.
  • Modo manual. Ajusta el interruptor a la posición manual, la bomba ahora no se apagará automáticamente, sino que realizará el bombeo, incluso si se alcanza el nivel de agua existente y la bomba se seca. Debes cortar la energía inmediatamente para evitar que la bobina se queme. Modo automatizado: ajusta el interruptor a la posición automática. Una vez que hayas conectado el dispositivo al enchufe, la bomba se encenderá automáticamente cuando el agua exceda el nivel de arranque y se apagará cuando se haya obtenido el nivel de parada. Esto significa que la bomba se puede dejar encendida en todo momento y mantendrá el agua en un sótano o barco, por ejemplo, en el nivel requerido. Ten en cuenta que esta bomba no está diseñada para ser utilizada continuamente, debe apagarse a intervalos regulares. Estructura de sellado y Construcción duradera: la bomba de sumidero cuenta con una estructura de sellado duradera y el cuerpo termoplástico duradero evita que la bomba se corroa. La placa base más alta asegura la prevención de la recogida de desechos en el pozo del sumidero.



Descripción del producto

bomba de sumidero

La bomba de agua Prostormer 1HP cuenta con una carcasa termoplástica duradera, tasa de entrega máxima de 3500 GPH, esta bomba sumergible es ideal para drenar agua de sótanos inundados, pozos de agua, garajes, estanque de jardín. Utiliza la función de interruptor de flotador integrado. Hace que la bomba funcione más estable y protege el interruptor de flotador de factores externos. La bomba de sumidero PROSTORMER utiliza una tecnología de sellado mecánico para sellar de manera más estable, sin fugas, durar más tiempo y consumir menos potencia de fricción.

bomba de sumidero

Tamaños de salida múltiples

2 conexiones de manguera, tamaños de diámetro interior: 1 pulgada y 1.25 pulgadas. 2 conexiones roscadas: 1 pulgada y 1.5 pulgadas.

bomba de sumidero

Interruptor de flotador integrado

Hace que la bomba funcione más estable y protege el interruptor de flotador de factores externos.

bomba de sumidero

2 modos de trabajo

Tiene dos mods de trabajo: modo manual y modo automatizado.

Placa base superior

Placa base superior

La bomba tiene una placa base más alta que garantiza la prevención de la recogida de desechos en el pozo del sumidero.

Escenas aplicables

bomba de sumidero

Estanque de jardín

bomba de sumidero

Riego agrícola

bomba de sumidero

Piscina

bomba de sumidero

Casa inundada

bomba de sumidero

Steven
Comentado en los Estados Unidos el 4 de abril de 2025
This has been working great as an emergency sump pump while I am getting my collapsed drainage fixed. With garden hose it's able to deal with most rain situationThe only confusing thing is the pump sometimes takes a while to get going. Manual seems to say it's pumping out air? I had thought it wasn't working right and tried to troubleshoot a few times
V A
Comentado en los Estados Unidos el 20 de junio de 2024
Worked to drain a huge pond that forms in my yard whenever it rains. It would drain an area about 15x15, maybe 6-8 inches deep, in about 2 hours. At one point, it did get clogged and I took it apart to free the float, but given it pumped out a LOT of dirt and leaves, I was pretty happy with it. I had to put it on a flat pan in the deepest part of the yard, because it didn't have enough clearance not to immediately clog on the bare ground, but the pan method worked well.You can set it to run constantly (and burn up when it's dry) or turn off when the float gets low. It was a little hard to figure out which way was which, as it's a raised bump on the plastic which was hard to read.The hose comes out straight up, which is fine for a well or deep pond, but i had to muddle together an elbow to connect my hose, otherwise it just folded over and cut off flow. It would be great if it came with an elbow piece along with the other two attachments.It's a little hard to get it going, as dropping it straight in will keep air inside, and it won't start. But with a bit of practice, I figured out how to angle it so all the air came out as it entered the water.Hope it works as well for next year.
Old_Hippie
Comentado en Canadá el 23 de septiembre de 2024
Extremely satisfied with the Pump. My question is it sturdy enough to spend the winter underneath my deck ?THX
Rick H.
Comentado en los Estados Unidos el 7 de junio de 2023
Update 1 year later...I have used this pump several times over the winter to drain water off my pool cover. It has worked flawlessly. This is hands down the best pump I've owned! Once you figure out your hose size connection, you're golden. I purchased a Superior Pump heavy duty 1.5" 25' lay flat discharge hose kit with 1.25, 1.5 discharge size. Clamp with a hose clamp and let it rip. I haven't had any debris that the pump will not mulch and suck through yet with no damage to the pump. I am particularly fond of the auto feature that shuts the pump off when the water level is too low to pump. I can walk away from it and forget about it. I highly recommend!!My pump showed up today, and I put it straight to work. Instructions weren't terrible, but could be a little clearer. I figured out the initial startup and air purge without any issues. It's a hefty little sucker, and for being plastic appears quite sturdy and we'll built. The two adapters that come with it seem thick and sturdy as well. If you're looking to hook up a yard hose to it then you're in luck. It will screw right on there with the supplied reducer. I bought it because of the 1 hp motor, and high flow rate, and I wanted to use a 1 1/2 inch hose. Unfortunately, the adapters that came with it are only reducers fro 1 12 inches. Now granted, the largest diameter reducer is 1 1/4 inches, so I cut off the excess smaller end and the hose fit with a hose clamp with some minor leakage. It did not appear to affect the pumping suction though. I will go purchase a threaded coupler from the hardware store and use the 1 1/2 inch adapter that I already have. Not a big deal really. I bought it to finish draining my pool for a deep clean. My old Wayne pump that I've had for years and rebuilt a couple of times finally decided to croak for good leaving about 2 ft of water in a 24 ft round pool. I was about to spend about 4 times more than this pump costs, and I thought for the price, why not?So I hooked up the hose, purged the air, and plugged it up. This sucker is a hoss!! It completely filled the 1.5 inch hose and started throwing some water! It drained the remaining water in under an hr. One note if you're not paying attention to detail...it only drains down to 3/4 inch. If you're looking for lower than that, look elsewhere. It was perfect for my needs. On a positive note, it will suck debris up to 1/2 inch, and I can tell you it does it effectively without any snafu's! Oh yeah, another plus is that it's very quiet which is nice.The only real downside that I see to this pump is the topside discharge. Once your water gets low enough, the weight of the hose will tip it over. So I had to babysit it for a bit close to the end. I believe that I will solve this by making a hard vertical pvc pipe with a 90 at the top with an extension to attach the hose to. It will be a fairly cheap fix and work well I think. You could adapt that setup to any situation that you have.Overall, I would highly recommend this pump after first use!! It performed flawlessly! The price point is unbeatable for a 3500 gal/ hr pump and a 1 hp motor. I will update after I've used it a few more times, but for now...5 stars!!
C. Ricks
Comentado en los Estados Unidos el 27 de mayo de 2023
No se pudo cargar el contenido.
Cliente de
Comentado en México el 13 de septiembre de 2023
BOMBA DE MUY BUENA CALIDAD Y FUNCIONAL. NO TENGO QUEJA Y FUNCIONÓ CORRECTAMENTE PARA DESAZOLVAR UN CUBO DE ELEVADOR QUE SE INUNDÓ POR LLUVIA. ES UN BUEN PRODUCTO.
Productos recomendados

Mex $5,390.00

Mex $ 1,881 .00 Mex $1,881.00

4.5
Elegir

Mex $5,007.19

Mex $ 1,881 .00 Mex $1,881.00

4.8
Elegir

Mex $920.00

Mex $ 423 .00 Mex $423.00

4.4
Elegir

Mex $221.00

Mex $ 114 .00 Mex $114.00

4.8
Elegir

Mex $280.00

Mex $ 148 .00 Mex $148.00

4.8
Elegir