No hay artículos en el carro
No hay artículos en el carroRandom customer
Comentado en los Estados Unidos el 11 de mayo de 2024
exceeded expectations. fantastic purchase. well-made and highly functional. Will buy again
Alex H
Comentado en los Estados Unidos el 10 de diciembre de 2024
Overall finish of parts is good. Polished sliding rods both run parallel and the sliding block rides them well. However the allen screw hole is not perpendicular to the block, and neither is the stop rod. See pics. While the stop rod being crooked won't affect my use, the threaded screw hole being non-square makes everything bind. Although I can get it to work I will be sending this item back. Apparently other reviewers did not have these problems...
David
Comentado en los Estados Unidos el 19 de noviembre de 2024
I’ve used this vise stop on a daily basis for the last couple months. No issues and it is holding up well. Good deal for the price
MJN
Comentado en los Estados Unidos el 12 de octubre de 2024
This stop securely attaches to the vise and provides good adjustability. Great addition to my mill.
paradug
Comentado en los Estados Unidos el 28 de noviembre de 2023
I am using QZATTCAEN’s milling vise jaw stop as a lathe carriage stop for my old Atlas 6” metal lathe. For this purpose, I had to put a small shim of cork under the lower jaw to get it to fit. The shim also ensures that there is no damage to the lathe’s way. The minimum distance of the jaw spacing when it is fully tightened is 11.5mm. This is a key dimension to determine if this stop will work with your vise or other application. The offering shows dimensions but not this one, so be sure to check before ordering.The manufacturing quality of the stop is adequate. The jaws and screws have a black finish and the guides and stop bar are bright with a ground finish. The stop represents good value for the cost point.
Productos recomendados