No hay artículos en el carro
No hay artículos en el carroAlan P
Comentado en los Estados Unidos el 22 de diciembre de 2024
My old no brand hardware store flaring tool just wasn't doing its job anymore, so I tried this. Makes excellent double flares for the brake lines on my '46 Mercury. It may seem a little pricey, but it works great for my needs.
Felipe Ponce
Comentado en México el 29 de septiembre de 2023
Pues no hay mucho que decir., simplemente calidad en el producto tanto en los terminados como en la fabricación ademas comprado a un excelente precio.
TR
Comentado en Canadá el 13 de marzo de 2020
As a professional HVAC installer I've probably done 50 copper gas lines per week since I received it without a single bad joint. I also use this for R410A ductless splits. A clutch model would have been nicer to use but this was more cost friendly. Great product otherwise.
Sebastien B
Comentado en Canadá el 10 de marzo de 2019
I bought this tool hoping it would do a better job than the cheap one I bought at Rona. This one is robust, and more importantly precise. Allowing flaring 3/8 in and 5/8 in tubes well enough for good connections on a r410 tube network for heat pump.
DR KRIS P MOREY
Comentado en Canadá el 14 de noviembre de 2019
If you do a little research on 45° flaring you will find no problem using this tool. It centers properly and works fantastic, it feels very premium and will last a long time.
A. C.
Comentado en los Estados Unidos el 15 de abril de 2013
I have always shied away from buying the big box store version of this tool because of the inconsistent results they give. Rest assured this is well made and yields excellent, clean flares that seal perfectly every time.UPDATE July 25, 2013 After using this to make a few hundred flares, it has held up well and performed flawlessly. All you have to do is cut the pipe cleanly, squarely, deburr and insert it ever so slightly proud of the block. tighten it down and pop out another perfect flare!
Productos recomendados