No hay artículos en el carro
No hay artículos en el carro El paquete incluye:
1 disco plano de diamante de 6 pulgadas.
Especificaciones:
Diámetro x agujero del árbol: 6 x 1/2 pulgadas
Grosor: 1,5 mm.
Grit: 80
Materiales: metal, diamante.
Características:
★ ¿Cuál es la función del disco Diamond?
Este disco de molienda de diamante está diseñado para lijar materiales extremadamente duros, tales como: piedra preciosa de mármol de granito, roca, vidrio, etc. Especialmente ideal para la molienda lapidaria de joyas. También se puede utilizar para afilar cuchillos, cuchillas, herramientas de metal.
★ ¿Para qué máquina se utiliza adecuada?
La rueda abrasiva de lijado plana es adecuada para máquinas de facetado de gemas, cabber inclinado lapidario para molienda general.
★ ¿Cuál es la ventaja del diseño?
El diseño extremadamente plano y paralelo hace que el disco se coloque completamente en la máquina de facetas, y logre los requisitos de facetado más exactamente.
★ ¿Cuáles son los materiales?
Metal de alta calidad con revestimiento de diamante en un lado, las partículas de diamante electrochapado proporcionan una larga vida útil.
Robert Lee Combs, Jr
Comentado en los Estados Unidos el 14 de abril de 2025
excellent product.
Greg W
Comentado en los Estados Unidos el 31 de agosto de 2024
Long wearing.
Marco
Comentado en los Estados Unidos el 16 de febrero de 2024
Got 2 of these to use back to back on my 6in grinder. One for steel other for aluminum.
Douglas Hufnagel
Comentado en los Estados Unidos el 19 de diciembre de 2024
Sharpens welding tungsten nicely.
Manuel
Comentado en México el 25 de abril de 2024
Funciona muy bien
Jay
Comentado en los Estados Unidos el 17 de julio de 2023
I bought three of these (120, 300, 600). They came nicely packaged but I was concerned about them getting dinged on the edge of bent because they used a plastic envelope instead of a box that could protect them in shipping. Of the three, only the 600 was without major flaws. It appears they use their worst blanks on larger grit sizes and flatter disks on smaller grits (600). The 600 was fairly flat, the 300 was pretty good, but the 120 is a potato chip wavy. The OD is a reasonable approximation of 6" but you can't get a true measurement because the outer edge is also electroplated with diamond. Unfortunately so is the inner hole which is a bit oversized so even with the diamond coating it fits over your spindle but will likely damage it. I don't expect them to run true.All of them have contamination on the back but most of it should wash off, except for the 120. The 120 had a coating on the back that is mostly peeled off, you can see the back of the 120 in the first picture. Even if the disk was flat then the partial coating would prevent it from laying flat on the master lap. They all had a raised burr on the back outer edge and the inner hole and there was diamond coating on the outside edge as well. On the outer edge of the 120 and 300, there's delamination of the diamond and electroplating that can be seen in all of the pictures as shiny areas.I guess now I'll find out of they read their review and find out how good their customer service actually is.
Productos recomendados
Mex $6,323.48
Mex $ 1,881 .00 Mex $1,881.00
Mex $269.00
Mex $ 137 .00 Mex $137.00