No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Descripción del Producto
Amplia compatible
TW
Comentado en Alemania el 31 de marzo de 2025
Wirklich ein top Resin. Klare Empfehlung. Man sieht den Unterschied in der Qualität der Drucke, verglichen mit den üblichen günstigeren.
Alberto
Comentado en España el 3 de febrero de 2025
Se supone que se lava al agua, no es asi. Al ver que no se lava al agua, he intentado hacer lo que recomienda el fabricante, usar una mezcla de ethanol+agua, dando ningun buen resultado. Al final me decidí por lavar solo con ethanol, tampoco dio resultado. Y no, no es falta de experiencia, llevo mas de 5 años usando impresoras de resina y con esta en concreto estoy teniendo recuerdos de mis primeros dias en este "hobby". Hay otras marcas que literalmente, bajo el grifo con agua tibia, se limpian y solo quedaría dejarlas secar tranquilamente encima de un paño seco. No la volvería a comprar, ni regalada vamos.
Leon74boy
Comentado en Francia el 30 de octubre de 2024
Comme d’hab la résine sirayatech reste incroyable quelque soit le model que vous choisissez
Cyrus F
Comentado en Singapur el 10 de agosto de 2022
No se pudo cargar el contenido.
K. Skelton
Comentado en los Estados Unidos el 9 de julio de 2020
[EDIT Aug 24, 2020I have several prints from around the time of my initial review (July 8). For this test I printed 3 models with each resin mix: 100% Simple, Simple mixed with 30% Blu and mixed with 50% Blu. All were washed in 99% isopropyl alcohol, 20% iso and 35% vodka then rinsed with tap water and cured with a UV lamp. To date I've had zero issues with "melting" as others have reported. I used the same settings as I do for Blu (which come from the Anycubic Photon Google Sheet that is available in a number of enthusiasts groups).The 100% Simple is about as brittle as other standard resins, subjectively. The 50% mix was a little sticky after the wash/rinse for non-99% iso washes, and I didn't notice a significant difference in subjective toughness compared with the 30% mix. I did notice a marked increase in smell as I increased the quantity of Blu. ]I am a fan of the Siraya Blu and when I heard about Simple I had to find out if the low odor and clean up with 15% alcohol claims were true. I was too excited to try this and loaded up a model that has settings for Blu without really thinking about it, and Simple printed beautifully. I also found that the smell was hardly noticeable.I put the prints in my ultrasonic cleaner with an approx 20% IPA solution and cleaned them for three minutes. I was very pleased that there wasn't any obvious resin on the surface. Blu, on the other hand frequently felt gummy despite being cleaned with 99% IPA. While removing the supports they felt stiffer and more brittle than with Blu, but this resin isn't claiming to be tough.I'm going to try mixing this with Blu to see if it gains flexibility while retaining its low viscosity and easy clean up.
Productos recomendados
Mex $890.00
Mex $ 427 .00 Mex $427.00
Mex $711.27
Mex $ 348 .00 Mex $348.00
Mex $377.15
Mex $ 188 .00 Mex $188.00
Mex $540.00
Mex $ 286 .00 Mex $286.00