No hay artículos en el carro
No hay artículos en el carroDescripción del producto
El soporte magnético plano para teléfono se puede montar en cualquier superficie plana y limpia (utiliza las toallitas de limpieza incluidas para limpiar el lugar de montaje):
salpicadero de cochewallmirrordeskmonitorbedrefrigerator
El soporte magnético para teléfono solo funciona utilizando las placas de metal en la parte posterior del teléfono o la funda o entre el teléfono y la funda (no usar con MAGSAFE a menos que desee utilizar placas de metal).
Instrucciones
Para instalar la placa de metal del teléfono, limpia la parte posterior de tu teléfono o funda de la suciedad, el polvo y el sudor con las toallitas o alcohol incluidas; pega la placa de montaje de metal redonda o rectangular incluida en la superficie plana limpia. Espera 2 horas antes de usar; limpia la superficie plana de la suciedad, el polvo, la cera del coche con las toallitas de suministros o alcohol. Pegue el soporte magnético para teléfono en el salpicadero de tu coche, pared u otra superficie. Espera 12 horas antes de usar; no olvides quitar la película protectora azul de la placa de metal cuando empieces a usar el soporte magnético para teléfono del coche.
Si la fuerza del magnetismo no es suficiente, utiliza 2 placas de metal juntas para hacer una doble lámina de acero. Este método aumentará el grosor del metal, lo que aumentará la fuerza de succión del imán.
Bri Guy
Comentado en Canadá el 18 de enero de 2025
Not a very strong magnet, But i got four So ... Ya
Snookfish
Comentado en los Estados Unidos el 25 de febrero de 2024
Placed one of the magnets on my Tesla MS dash, and it did not hold my phone. So, I added another, and another. Now three magnets on my dash, and my Galaxy Note 10 falls off whenever I accelerate. The kit comes with lots of helpful stuff, but overall the magnets are not strong enough to hold my phone, which is not large by today's standards. Now I need to remove these things from my dash!
malgorzata
Comentado en Canadá el 6 de noviembre de 2024
It's been a month now and it's holding up well
bithead
Comentado en los Estados Unidos el 4 de septiembre de 2023
Update 10-18-2023:================Even with my improvised method of getting the plate to stick to the phone, the phone would not stay mounted. Falling was far less frequent, lasting 2 to 3 weeks instead of a few hours, but since my initial review, it has fallen off several times, leaving the plate attached to the magnet instead of the phone. So here I am, reducing the rating from 2 stars to 1. As a side note, it was not possible to simply pull the magnet off of the fridge - I had to use a putty knife to slip under it and pry it off. On the upside there was no damage to the fridge surface as a result of this.Original Review:=============I purchased this to mount an old phone on my refrigerator, so I could use it as a small tablet in the kitchen. After cleaning and installing the plate on the phone, and the magnet on the fridge, then waiting the recommended 12 hours, all looked good. Until a couple of hours later when I walked into the kitchen and found the phone laying on the floor. The metal plate that I had attached to the phone was still on the magnet - the adhesive on the plate was unable to stay attached to the phone. This was using a rectangular plate which has more surface area than the round ones. Noting that the back of the phone is slightly curved and a little porous for a non-slip grip, I thought perhaps the smaller round plate, requiring less surface contact, might adhere better. Again, all looked good at first, but a couple of hours later, I again found the phone on the floor and the plate stuck to the magnet and not to the phone.I think I've found a solution (thus 2 stars instead of 1)... the product comes with spare 3M adhesive pads which are used on the magnets to adhere them to the mount surface (fridge in my case). These are double-sided, with the 3M label on one side and clear protection on the other. The 3M label side offers stronger adhesive than a different adhesive used on the plates to attach to the phone. So I placed one of these between the phone and the plate, with the 3M label side attached to the phone and the clear adhesive side attached to the adhesive side of the metal plate. So far this is working. It's been 16+ hours since I last mounted the phone, and it is still where I left it. If in the near future I find the phone on the floor again, I'll be back to downgrade my rating. Hopefully that won't be needed!
Luis Campero
Comentado en México el 14 de noviembre de 2022
cumple su funcion
Daniel
Comentado en los Estados Unidos el 23 de octubre de 2022
It works super sticky it’s like super glue
Productos recomendados
Mex $276.09
Mex $ 165 .00 Mex $165.00
Mex $294.11
Mex $ 155 .00 Mex $155.00